Lines Matching +full:generic +full:- +full:ohci

12 	---help---
25 	bool "DesignWare USB3 DRD Generic OF Simple Glue Layer"
43 	bool "Support for PCI-based xHCI USB controller"
47 	  Enables support for the PCI-based xHCI controller.
72 	---help---
78 	  EHCI controllers are packaged with "companion" host controllers (OHCI
82 	  probably configure the OHCI (for NEC and some other vendors) USB Host
91 	bool  "Support for Atmel on-chip EHCI USB controller"
94 	---help---
95 	  Enables support for the on-chip EHCI controller on Atmel chips.
98 	bool "Support for Marvell on-chip EHCI USB controller"
101 	---help---
102 	  Enables support for the on-chip EHCI controller on MVEBU SoCs.
105 	bool "Support for i.MX6/i.MX7ULP on-chip EHCI USB controller"
108 	---help---
109 	  Enables support for the on-chip EHCI controller on i.MX6 SoCs.
112 	bool "Support for i.MX7 on-chip EHCI USB controller"
115 	---help---
116 	  Enables support for the on-chip EHCI controller on i.MX7 SoCs.
119 	bool "Support for OMAP3+ on-chip EHCI USB controller"
122 	---help---
123 	  Enables support for the on-chip EHCI controller on OMAP3 and later
127 	bool "Support for Vybrid on-chip EHCI USB controller"
131 	  Enables support for the on-chip EHCI controller on Vybrid SoCs.
137 	---help---
143 	bool "Support for Qualcomm on-chip EHCI USB controller"
147 	---help---
148 	  Enables support for the on-chip EHCI controller on Qualcomm
154 	bool "Support for PCI-based EHCI USB controller"
157 	  Enables support for the PCI-based EHCI controller.
160 	bool "Support for Xilinx Zynq on-chip EHCI USB controller"
163 	---help---
164 	  Enable support for Zynq on-chip EHCI USB controller
167 	bool "Support for generic EHCI USB controller"
171 	---help---
172 	  Enables support for generic EHCI controller.
177 	bool "OHCI HCD (USB 1.1) support"
178 	---help---
179 	  The Open Host Controller Interface (OHCI) is a standard for accessing
181 	  UHCI specification.  If your USB host controller follows the OHCI spec,
182 	  say Y.  On most non-x86 systems, and on x86 hardware that's not using a
185 	  based system where you're not sure, the "lspci -v" entry will list the
186 	  right "prog-if" for your USB controller(s):  EHCI, OHCI, or UHCI.
189 	bool "Support for PCI-based OHCI USB controller"
193 	  Enables support for the PCI-based OHCI controller.
198 	bool "Support for generic OHCI USB controller"
202 	---help---
203 	  Enables support for generic OHCI controller.
206 	bool "Support for da850 OHCI USB controller"
215 	---help---
233 	---help---
235 	  USB-Implementers Forum (USB-IF) USB 2.0 specifications.
236 	  Hi-Speed (480 Mbps), Full-Speed (12 Mbps), and Low-Speed (1.5 Mbps)
244 	---help---
257 	---help---
258 	  This enables support for the on-chip Renesas R8A66597 USB 2.0