Lines Matching +full:peripheral +full:- +full:to +full:- +full:memory
3 # (a) a peripheral controller, and
6 # NOTE: Gadget support ** DOES NOT ** depend on host-side CONFIG_USB !!
8 # - Host systems (like PCs) need CONFIG_USB (with "A" jacks).
9 # - Peripherals (like PDAs) need CONFIG_USB_GADGET (with "B" jacks).
10 # - Some systems have both kinds of controllers.
12 # With help from a special transceiver and a "Mini-AB" jack, systems with
13 # both kinds of controller can also support "USB On-the-Go" (CONFIG_USB_OTG).
20 host (such as a PC) controlling up to 127 peripheral devices.
21 The USB hardware is asymmetric, which makes it easier to set up:
22 you can't connect a "to-the-host" connector to a peripheral.
24 U-Boot can run in the host, or in the peripheral. In both cases
26 talking to it. Peripheral controllers are often discrete silicon,
32 Enable this configuration option if you want to run U-Boot inside
33 a USB peripheral device. Configure one hardware driver for your
34 peripheral/device side bus controller, and a "gadget driver" for
35 your peripheral protocol.
42 default "U-Boot"
44 Vendor name of the USB device emulated, reported to the host device.
52 Vendor ID of the USB device emulated, reported to the host device.
61 Product ID of the USB device emulated, reported to the host device.
67 USBA is the integrated high-speed USB Device controller on
79 The Designware USB2.0 high-speed gadget controller
81 driver to operate in Peripheral mode. This option requires
82 USB_GADGET to be enabled.
87 bool "DesignWare USB2.0 HS OTG controller 8-bit PHY bus width"
89 Set the Designware USB2.0 high-speed OTG controller
90 PHY interface width to 8 bits, rather than the default (16 bits).
98 Say Y here to enable device controller functionality of the
102 int "Maximum VBUS Power usage (2-500 mA)"
106 Some devices need to draw power from USB when they are
107 configured, perhaps to operate circuitry or to recharge
108 batteries. This is in addition to any local power supply,
112 milliAmperes. The permitted range of values is 2 - 500 mA;
115 This value will be used except for system-specific gadget
118 # Selected by UDC drivers that support high-speed operation.
133 Enable Serial Download Protocol (SDP) device support in U-Boot. This
134 allows to download images into memory and execute (jump to) them
143 Creates an Ethernet network device through a USB peripheral
145 (U-Boot) and the host (remote device) that can be used just like any
147 It will bind on the peripheral USB controller, ignoring the USB hosts
156 There is several models (protocols) to implement Ethernet over USB
157 devices. The main ones are Microsoft's RNDIS and USB's CDC-Ethernet
158 (also called CDC-ECM). RNDIS is obviously compatible with Windows,
159 while CDC-ECM is not. Most other operating systems support both, so
160 if inter-operability is a concern, RNDIS is to be preferred.
163 bool "CDC-ECM Protocol"
174 Microsoft proprietary protocol to create an Ethernet device over USB.
184 Ethernet MAC address of the device-side (ie. local board's) MAC
191 Ethernet MAC address of the host-side (ie. remote device's) MAC