Lines Matching +full:peripheral +full:- +full:controller

3 #    (a) a peripheral controller, and
6 # NOTE:  Gadget support ** DOES NOT ** depend on host-side CONFIG_USB !!
8 #  - Host systems (like PCs) need CONFIG_USB (with "A" jacks).
9 #  - Peripherals (like PDAs) need CONFIG_USB_GADGET (with "B" jacks).
10 #  - Some systems have both kinds of controllers.
12 # With help from a special transceiver and a "Mini-AB" jack, systems with
13 # both kinds of controller can also support "USB On-the-Go" (CONFIG_USB_OTG).
20 	   host (such as a PC) controlling up to 127 peripheral devices.
22 	   you can't connect a "to-the-host" connector to a peripheral.
24 	   U-Boot can run in the host, or in the peripheral.  In both cases
25 	   you need a low level bus controller driver, and some software
26 	   talking to it.  Peripheral controllers are often discrete silicon,
32 	   Enable this configuration option if you want to run U-Boot inside
33 	   a USB peripheral device.  Configure one hardware driver for your
34 	   peripheral/device side bus controller, and a "gadget driver" for
35 	   your peripheral protocol.
42 	default "U-Boot"
67 	  USBA is the integrated high-speed USB Device controller on
76 	bool "DesignWare USB2.0 HS OTG controller (gadget mode)"
79 	  The Designware USB2.0 high-speed gadget controller
81 	  driver to operate in Peripheral mode. This option requires
87 	bool "DesignWare USB2.0 HS OTG controller 8-bit PHY bus width"
89 	  Set the Designware USB2.0 high-speed OTG controller
95 	bool "ChipIdea device controller"
98 	  Say Y here to enable device controller functionality of the
102 	int "Maximum VBUS Power usage (2-500 mA)"
112 	   milliAmperes.  The permitted range of values is 2 - 500 mA;
115 	   This value will be used except for system-specific gadget
118 # Selected by UDC drivers that support high-speed operation.
133 	  Enable Serial Download Protocol (SDP) device support in U-Boot. This
143 	  Creates an Ethernet network device through a USB peripheral
144 	  controller. This will create a network interface on both the device
145 	  (U-Boot) and the host (remote device) that can be used just like any
147 	  It will bind on the peripheral USB controller, ignoring the USB hosts
157 	  devices. The main ones are Microsoft's RNDIS and USB's CDC-Ethernet
158 	  (also called CDC-ECM). RNDIS is obviously compatible with Windows,
159 	  while CDC-ECM is not. Most other operating systems support both, so
160 	  if inter-operability is a concern, RNDIS is to be preferred.
163 	bool "CDC-ECM Protocol"
184 	  Ethernet MAC address of the device-side (ie. local board's) MAC
191 	  Ethernet MAC address of the host-side (ie. remote device's) MAC