Lines Matching +full:device +full:- +full:tree

19 	  This provides Linux-compatible device tree interface for the pinctrl
20 	  subsystem.  This feature depends on device tree configuration because
21 	  it parses a device tree to look for the pinctrl device which the
22 	  peripheral device is associated with.
24 	  If this option is disabled (it is the only possible choice for non-DT
27 	  It is totally up to the implementation of each low-level driver.
40 	  If you need to handle vendor-specific DT properties, you can disable
53 	  The driver is typically controlled by the device tree.
66 	  This option is an SPL-variant of the PINCTRL option.
75 	  This option is an SPL-variant of the PINCTRL_FULL option.
83 	  This option is an SPL-variant of the PINCTRL_GENERIC option.
91 	  This option is an SPL-variant of the PINMUX option.
95 	  driver or in the device tree. If this is acceptable and you need
96 	  to adjust pin multiplexing in SPL in order to boot into U-Boot,
97 	  enable this option. You will need to enable device tree in SPL
104 	  This option is an SPL-variant of the PINCONF option.
114 	  The driver is controlled by a device tree node which contains
125 	  AT91 PIO controller is a combined gpio-controller, pin-mux and
126 	  pin-config module. Each I/O pin may be dedicated as a general-purpose
129 	  one-half of peripheral clock cycle and a debouncing filter providing
131 	  can also control the multi-driver capability, pull-up and pull-down
156 	bool "Microchip PIC32 pin-control and pin-mux driver"
162 	  SoCs. This driver is controlled by a device tree node which
171 	  The driver is controlled by a device tree node which contains both
182 	  The driver is controlled by a device tree node which contains both
191 	  This option is an SPL-variant of the PINCTRL_ROCKCHIP option.
204 	bool "Single register pin-control and pin-multiplex driver"
215 	bool "STMicroelectronics STi pin-control and pin-mux driver"
221 	  The driver is controlled by a device tree node which contains both
231 	  The driver is controlled by a device tree node which contains both
242 	i.e. it uses the same device tree configuration.