Lines Matching full:mx28
11 and MX28.
25 4) Installation of U-Boot into NAND flash on a MX28 based board
26 5) Installation of U-Boot into SPI NOR flash on a MX28 based board
33 tool is built automatically when compiling U-Boot for i.MX23 or i.MX28.
43 longer necessary for general use of U-Boot on i.MX23 and i.MX28.
143 to MX28 manual, section 12.2.1 (Table 12-2) or MX23 manual, section 35.1.2
188 4) Installation of U-Boot into NAND flash on a MX28 based board
191 To boot a MX28 based board from NAND, set the boot mode DIP switches according
192 to MX28 manual section 12.2.1 (Table 12-2), PORT=GPMI, NAND 1.8 V.
214 on the MX28 board by issuing the "nand info" command.
255 see MX28 manual section 12.12.1.2 and 12.12.1.3.
267 5) Installation of U-Boot into SPI NOR flash on a MX28 based board
288 according to MX28 manual section 12.2.1 (Table 12-2)