board/udoo/udoo.c

6  * SPDX-License-Identifier:	GPL-2.0+
10 #include <asm/arch/imx-regs.h>
13 #include <asm/arch/mx6-pins.h>
16 #include <asm/mach-imx/iomux-v3.h>
17 #include <asm/mach-imx/sata.h>
45 	gd->ram_size = imx_ddr_size();  in dram_init()
72 	 * Bug: Apparently uDoo does not works with Gigabit switches...  in mx6_rgmii_rework()
79 	/* control data pad skew - devaddr = 0x02, register = 0x04 */  in mx6_rgmii_rework()
83 	/* rx data pad skew - devaddr = 0x02, register = 0x05 */  in mx6_rgmii_rework()
87 	/* tx data pad skew - devaddr = 0x02, register = 0x05 */  in mx6_rgmii_rework()
91 	/* gtx and rx clock pad skew - devaddr = 0x02, register = 0x08 */  in mx6_rgmii_rework()
113 	/* pin 32 - 1 - (MODE0) all */
115 	/* pin 31 - 1 - (MODE1) all */
117 	/* pin 28 - 1 - (MODE2) all */
119 	/* pin 27 - 1 - (MODE3) all */
121 	/* pin 33 - 1 - (CLK125_EN) 125Mhz clockout enabled */
192 	bus = fec_get_miibus(base, -1);  in board_eth_init()
194 		return -EINVAL;  in board_eth_init()
199 		ret = -EINVAL;  in board_eth_init()
202 	printf("using phy at %d\n", phydev->addr);  in board_eth_init()
203 	ret  = fec_probe(bis, -1, base, bus, phydev);  in board_eth_init()
236 	if (phydev->drv->config)  in board_phy_config()
237 		phydev->drv->config(phydev);  in board_phy_config()
245 	gd->bd->bi_boot_params = PHYS_SDRAM + 0x100;  in board_init()