Lines Matching refs:EVM

1 U-Boot port for Texas Instruments Keystone II EVM boards
6 This README has information on the U-Boot port for K2HK, K2E, and K2L EVM boards.
8 http://www.advantech.com/Support/TI-EVM/EVMK2HX_sd.aspx
87 on EVM. See instructions at below link for installing CCS on a Windows PC.
91 on EVM. Follow instructions at
98 and Power ON the EVM.  Follow instructions to connect serial port of EVM to
105 loading the U-Boot binary on the target EVM. Instead do the following:-
142    EVM using CCS", but using address 0x87000000.
148    Once U-Boot prompt is available, Power OFF the EVM. Set the SW1 dip switch
151 6. Power ON the EVM. The EVM now boots with U-Boot image on the NOR flash.
162    through CCS as described in step 2 of "Load and Run U-Boot on K2HK EVM
168    Once U-Boot prompt is available, Power OFF the EVM. Set the SW1 dip switch
171 6. Power ON the EVM. The EVM now boots with U-Boot image on the NAND flash.
179 2. Using BMC terminal set the ARM-UART bootmode and reboot the EVM
193 4. Insert SD card and Power on the EVM.
194    The EVM now boots with U-Boot image from SD card.