siemens/taurus/taurus.c

6  * U-Boot file: board/atmel/at91sam9260ek/at91sam9260ek.c
8  * (C) Copyright 2007-2008
12  * SPDX-License-Identifier:	GPL-2.0+
51 	struct at91_matrix *matrix = (struct at91_matrix *)ATMEL_BASE_MATRIX;  in taurus_nand_hw_init()  local
55 	csa = readl(&matrix->ebicsa);  in taurus_nand_hw_init()
57 	writel(csa, &matrix->ebicsa);  in taurus_nand_hw_init()
62 	       &smc->cs[3].setup);  in taurus_nand_hw_init()
65 	       &smc->cs[3].pulse);  in taurus_nand_hw_init()
67 	       &smc->cs[3].cycle);  in taurus_nand_hw_init()
72 	       &smc->cs[3].mode);  in taurus_nand_hw_init()
90 	writel((readl(&mat->scfg[3]) & (~AT91_MATRIX_SLOT_CYCLE))  in matrix_init()
92 			&mat->scfg[3]);  in matrix_init()
172 	writel(readl(&ma->ebicsa) | AT91_MATRIX_CS1A_SDRAMC |  in sdramc_configure()
174 		&ma->ebicsa);  in sdramc_configure()
193 	 * To find mirror addresses depends how the collumns are connected  in mem_init()
196 	 * behaves like normal SRAM with A0,A1,A2,etc. connected incremantal  in mem_init()
228 	 * Disable pull-up on:  in taurus_macb_hw_init()
236 	 * PHY has internal pull-down  in taurus_macb_hw_init()
249 	at91_set_gpio_input(AT91_PIN_PA25, 1);   /* ERST tri-state */  in taurus_macb_hw_init()
251 	/* Re-enable pull-up */  in taurus_macb_hw_init()
323 	gd->bd->bi_boot_params = CONFIG_SYS_SDRAM_BASE + 0x100;  in board_init()
343 	gd->ram_size = get_ram_size((void *)CONFIG_SYS_SDRAM_BASE,  in dram_init()
388 		return -ENOENT;  in upgrade_failure_fallback()
439 			return -1;  in do_upgrade_available()