Lines Matching +full:usb +full:- +full:b +full:- +full:connector
2 --------
3 The LS2080A Reference Design (RDB) is a high-performance computing,
7 The LS2081A Reference Design (RDB) is a high-performance computing,
12 --------------------------------------
13 Please refer arch/arm/cpu/armv8/fsl-layerscape/doc/README.soc for LS2080A,
17 -----------------------
18 - SERDES Connections, 16 lanes supporting:
19 - PCI Express - 3.0
20 - SATA 3.0
21 - XFI
22 - DDR Controller
23 - Two ports of 72-bits (8-bits ECC) DDR4. Each port supports four
24 chip-selects and two DIMM connectors. Support is up to 2133MT/s.
25 - One port of 40-bits (8-bits ECC) DDR4 which supports four chip-selects
27 -IFC/Local Bus
28 - IFC rev. 2.0 implementation supporting Little Endian connection scheme.
29 - 128 MB NOR flash 16-bit data bus
30 - One 2 GB NAND flash with ECC support
31 - CPLD connection
32 - USB 3.0
33 - Two high speed USB 3.0 ports
34 - First USB 3.0 port configured as Host with Type-A connector
35 - Second USB 3.0 port configured as OTG with micro-AB connector
36 - SDHC adapter
37 - SD Card Rev 2.0 and Rev 3.0
38 - DSPI
39 - 128 MB high-speed flash Memory for boot code and storage (up to 108MHz)
40 - 4 I2C controllers
41 - Two SATA onboard connectors
42 - UART
43 - ARM JTAG support
46 -------------------------
49 - Hosts LS2081A SoC
50 - Default boot source is QSPI-boot
51 - Does not have IFC interface
52 - RTC and QSPI flash devices are different
53 - Provides QIXIS access via I2C
56 ----------------------------
66 Other addresses are either reserved, or not used directly by U-Boot.
70 -------------------------------
71 During boot i.e. IFC Region #1:-
72 0x30000000 - 0x37ffffff : 128MB : NOR flash
73 0x3C000000 - 0x40000000 : 64MB : CPLD
75 After relocate to DDR i.e. IFC Region #2:-
83 ---------------
85 b) NAND boot
89 -------------------------
92 Boot firmware (U-Boot) 0x00100000
114 -------------------------
117 Boot firmware (U-Boot) 0x00100000
126 Booting Linux flavors which do not support 48-bit VA (< Linux 3.18)
127 -------------------------------------------------------------------
129 not support 48-bit VA (for e.g. < Linux 3.18) by appending mem=2048M, as shown