Lines Matching +full:sun4i +full:- +full:a10 +full:- +full:emac
6 * This file is dual-licensed: you can use it either under the terms
45 /dts-v1/;
46 #include "sun4i-a10.dtsi"
47 #include "sunxi-common-regulators.dtsi"
49 #include <dt-bindings/gpio/gpio.h>
50 #include <dt-bindings/pinctrl/sun4i-a10.h>
54 compatible = "jesurun,q5", "allwinner,sun4i-a10";
61 stdout-path = "serial0:115200n8";
65 compatible = "gpio-leds";
66 pinctrl-names = "default";
67 pinctrl-0 = <&led_pins_q5>;
76 reg_emac_3v3: emac-3v3 {
77 compatible = "regulator-fixed";
78 pinctrl-names = "default";
79 pinctrl-0 = <&emac_power_pin_q5>;
80 regulator-name = "emac-3v3";
81 regulator-min-microvolt = <3300000>;
82 regulator-max-microvolt = <3300000>;
83 startup-delay-us = <20000>;
84 enable-active-high;
101 &emac {
102 pinctrl-names = "default";
103 pinctrl-0 = <&emac_pins_a>;
113 pinctrl-names = "default";
114 pinctrl-0 = <&i2c0_pins_a>;
118 compatible = "x-powers,axp209";
122 interrupt-controller;
123 #interrupt-cells = <1>;
128 pinctrl-names = "default";
129 pinctrl-0 = <&ir0_rx_pins_a>;
134 phy-supply = <®_emac_3v3>;
137 phy1: ethernet-phy@1 {
143 pinctrl-names = "default";
144 pinctrl-0 = <&mmc0_pins_a>, <&mmc0_cd_pin_reference_design>;
145 vmmc-supply = <®_vcc3v3>;
146 bus-width = <4>;
147 cd-gpios = <&pio 7 1 GPIO_ACTIVE_HIGH>; /* PH1 */
148 cd-inverted;
181 regulator-boot-on;
194 pinctrl-names = "default";
195 pinctrl-0 = <&uart0_pins_a>;
205 usb0_vbus-supply = <®_usb0_vbus>;
206 usb1_vbus-supply = <®_usb1_vbus>;
207 usb2_vbus-supply = <®_usb2_vbus>;