Lines Matching +full:sun4i +full:- +full:a10 +full:- +full:emac
6 * This file is dual-licensed: you can use it either under the terms
45 /dts-v1/;
46 #include "sun4i-a10.dtsi"
47 #include "sunxi-common-regulators.dtsi"
49 #include <dt-bindings/gpio/gpio.h>
50 #include <dt-bindings/pinctrl/sun4i-a10.h>
54 compatible = "mele,a1000", "allwinner,sun4i-a10";
61 stdout-path = "serial0:115200n8";
65 compatible = "gpio-leds";
66 pinctrl-names = "default";
67 pinctrl-0 = <&led_pins_a1000>;
77 default-state = "on";
81 reg_emac_3v3: emac-3v3 {
82 compatible = "regulator-fixed";
83 pinctrl-names = "default";
84 pinctrl-0 = <&emac_power_pin_a1000>;
85 regulator-name = "emac-3v3";
86 regulator-min-microvolt = <3300000>;
87 regulator-max-microvolt = <3300000>;
88 startup-delay-us = <20000>;
89 enable-active-high;
94 compatible = "simple-audio-card";
95 simple-audio-card,name = "On-board SPDIF";
97 simple-audio-card,cpu {
98 sound-dai = <&spdif>;
101 simple-audio-card,codec {
102 sound-dai = <&spdif_out>;
106 spdif_out: spdif-out {
107 #sound-dai-cells = <0>;
108 compatible = "linux,spdif-dit";
128 &emac {
129 pinctrl-names = "default";
130 pinctrl-0 = <&emac_pins_a>;
140 pinctrl-names = "default";
141 pinctrl-0 = <&i2c0_pins_a>;
145 compatible = "x-powers,axp209";
149 interrupt-controller;
150 #interrupt-cells = <1>;
155 pinctrl-names = "default";
156 pinctrl-0 = <&ir0_rx_pins_a>;
161 phy-supply = <®_emac_3v3>;
164 phy1: ethernet-phy@1 {
170 pinctrl-names = "default";
171 pinctrl-0 = <&mmc0_pins_a>, <&mmc0_cd_pin_reference_design>;
172 vmmc-supply = <®_vcc3v3>;
173 bus-width = <4>;
174 cd-gpios = <&pio 7 1 GPIO_ACTIVE_HIGH>; /* PH1 */
175 cd-inverted;
212 pinctrl-names = "default";
213 pinctrl-0 = <&spdif_tx_pins_a>;
218 pinctrl-names = "default";
219 pinctrl-0 = <&uart0_pins_a>;
224 usb1_vbus-supply = <®_usb1_vbus>;
225 usb2_vbus-supply = <®_usb2_vbus>;