arm/dts/exynos5800-peach-pi.dts

2  * SAMSUNG/GOOGLE Peach-Pit board device tree source
7  * SPDX-License-Identifier:	GPL-2.0+
10 /dts-v1/;
15 	cpu-model = "Exynos5800";
17 	compatible = "google,pit-rev#", "google,pit",
21 		google,bad-wake-gpios = <&gpx0 6 GPIO_ACTIVE_HIGH>;
22 		hwid = "PIT TEST A-A 7848";
23 		lazy-init = <1>;
34 		compatible = "pwm-backlight";
36 		brightness-levels = <0 100 500 1000 1500 2000 2500 2800>;
37 		default-brightness-level = <7>;
38 		enable-gpios = <&gpx2 2 GPIO_ACTIVE_HIGH>;
39 		power-supply = <&tps65090_fet1>;
44 		power-supply = <&tps65090_fet6>;
49 				remote-endpoint = <&dp_out>;
55 		mem-manuf = "samsung";
56 		mem-type = "ddr3";
57 		clock-frequency = <800000000>;
58 		arm-frequency = <900000000>;
62 		samsung,min-temp	= <25>;
63 		samsung,max-temp	= <125>;
64 		samsung,start-warning	= <95>;
65 		samsung,start-tripping	= <105>;
66 		samsung,hw-tripping	= <110>;
67 		samsung,efuse-min-value	= <40>;
68 		samsung,efuse-value	= <55>;
69 		samsung,efuse-max-value	= <100>;
71 		samsung,dc-value	= <25>;
76 		clock-frequency = <400000>;
77 		power-regulator@9 {
78 			compatible = "maxim,max77802-pmic";
84 		clock-frequency = <100000>;
87 	              compatible = "maxim,max98090-codec";
92                 samsung,codec-type = "max98090";
96 		clock-frequency = <400000>;
103 	spi@12d30000 { /* spi1 */
104 		spi-max-frequency = <50000000>;
112 			elog-panic-event-offset = <0x01e00000 0x100000>;
114 			elog-shrink-size = <0x400>;
115 			elog-full-threshold = <0xc00>;
120 		samsung,vbus-gpio = <&gph0 0 GPIO_ACTIVE_HIGH>;
124 		samsung,vbus-gpio = <&gph0 1 GPIO_ACTIVE_HIGH>;
128 		samsung,vl-freq = <60>;
129 		samsung,vl-col = <1920>;
130 		samsung,vl-row = <1080>;
131 		samsung,vl-width = <1920>;
132 		samsung,vl-height = <1080>;
134 		samsung,vl-clkp;
135 		samsung,vl-dp;
136 		samsung,vl-bpix = <4>;
138 		samsung,vl-hspw = <80>;
139 		samsung,vl-hbpd = <172>;
140 		samsung,vl-hfpd = <60>;
141 		samsung,vl-vspw = <10>;
142 		samsung,vl-vbpd = <25>;
143 		samsung,vl-vfpd = <10>;
144 		samsung,vl-cmd-allow-len = <0xf>;
146 		samsung,power-on-delay = <30000>;
148 		samsung,interface-mode = <1>;
149 		samsung,dp-enabled = <1>;
150 		samsung,dual-lcd-enabled = <0>;
152 		samsung,bl-en-gpio = <&gpx2 2 GPIO_ACTIVE_HIGH>;
158 	samsung,color-space = <0>;
159 	samsung,dynamic-range = <0>;
160 	samsung,ycbcr-coeff = <0>;
161 	samsung,color-depth = <1>;
162 	samsung,link-rate = <0x0a>;
163 	samsung,lane-count = <2>;
164 	samsung,hpd-gpio = <&gpx2 6 GPIO_ACTIVE_HIGH>;
169 				remote-endpoint = <&panel_in>;
176 	spi-max-frequency = <3125000>;
177 	spi-deactivate-delay = <200>;
179 	num-cs = <1>;
180 	samsung,spi-src-clk = <0>;
181 	cs-gpios = <&gpb1 2 0>;
183 	cros_ec: cros-ec@0 {
184 		compatible = "google,cros-ec-spi";
185 		interrupt-parent = <&gpx1>;
188 		spi-half-duplex;
189 		spi-max-timeout-ms = <1100>;
190 		ec-interrupt = <&gpx1 5 GPIO_ACTIVE_LOW>;
193 		 * This describes the flash memory within the EC. Note
196 		#address-cells = <1>;
197 		#size-cells = <1>;
200 			erase-value = <0>;
203 		controller-data {
204 			samsung,spi-feedback-delay = <1>;
207 		i2c_tunnel: i2c-tunnel {
208 			compatible = "google,cros-ec-i2c-tunnel";
209 			#address-cells = <1>;
210 			#size-cells = <0>;
211 			google,remote-bus = <0>;
213 			battery: sbs-battery@b {
214 				compatible = "sbs,sbs-battery";
216 				sbs,poll-retry-count = <1>;
217 				sbs,i2c-retry-count = <2>;
220 			power-regulator@48 {
226 						ti,enable-ext-control;
229 						ti,enable-ext-control;
232 						ti,enable-ext-control;
235 						regulator-name = "vcd_led";
238 						regulator-name = "video_mid";
239 						regulator-always-on;
242 						regulator-name = "wwan_r";
243 						regulator-always-on;
246 						regulator-name = "sdcard";
247 						regulator-always-on;
250 						regulator-name = "camout";
251 						regulator-always-on;
254 						regulator-name = "lcd_vdd";
257 						regulator-name = "video_mid_1a";
258 						regulator-always-on;
267 					compatible = "ti,tps65090-charger";
274 #include "cros-ec-keyboard.dtsi"