arm/dts/exynos5420-peach-pit.dts

2  * SAMSUNG/GOOGLE Peach-Pit board device tree source
7  * SPDX-License-Identifier:	GPL-2.0+
10 /dts-v1/;
12 #include <dt-bindings/clock/maxim,max77802.h>
13 #include <dt-bindings/regulator/maxim,max77802.h>
18 	compatible = "google,pit-rev#", "google,pit",
22 		google,bad-wake-gpios = <&gpx0 6 GPIO_ACTIVE_HIGH>;
23 		hwid = "PIT TEST A-A 7848";
24 		lazy-init = <1>;
35 		compatible = "pwm-backlight";
37 		brightness-levels = <0 100 500 1000 1500 2000 2500 2800>;
38 		default-brightness-level = <7>;
39 		power-supply = <&tps65090_fet1>;
43 		mem-manuf = "samsung";
44 		mem-type = "ddr3";
45 		clock-frequency = <800000000>;
46 		arm-frequency = <900000000>;
50 		samsung,min-temp	= <25>;
51 		samsung,max-temp	= <125>;
52 		samsung,start-warning	= <95>;
53 		samsung,start-tripping	= <105>;
54 		samsung,hw-tripping	= <110>;
55 		samsung,efuse-min-value	= <40>;
56 		samsung,efuse-value	= <55>;
57 		samsung,efuse-max-value	= <100>;
59 		samsung,dc-value	= <25>;
64 		clock-frequency = <400000>;
65 		power-regulator@9 {
66 			compatible = "maxim,max77802-pmic";
72 		clock-frequency = <100000>;
75 	              compatible = "maxim,max98090-codec";
78 		edp-lvds-bridge@48 {
81 			sleep-gpios = <&gpx3 5 GPIO_ACTIVE_LOW>;
82 			reset-gpios = <&gpy7 7 GPIO_ACTIVE_LOW>;
116 				0x04 0x7a 0xfd  /* [7:5] DCO_FTRNG=+-40% */
122 				0x04 0xc1 0x92  /* Gitune=-37% */
128 				* 75% (250mV swing)
132 				* [7:6] Right-bar GPIO output strength is 8mA
186 				* Set LVDS output as 6bit-VESA mapping,
193 				* Set SSC enabled and +/-1% central
199 				0x04 0x54 0x14  /* LC -> RCO */
205 						remote-endpoint = <&panel_in>;
211 						remote-endpoint = <&dp_out>;
219                 samsung,codec-type = "max98090";
223 		clock-frequency = <400000>;
232 		power-supply = <&tps65090_fet6>;
237 				remote-endpoint = <&bridge_out>;
243 		spi-max-frequency = <50000000>;
245 			compatible = "spi-flash";
252 			elog-panic-event-offset = <0x01e00000 0x100000>;
254 			elog-shrink-size = <0x400>;
255 			elog-full-threshold = <0xc00>;
260 		samsung,vbus-gpio = <&gph0 0 GPIO_ACTIVE_HIGH>;
264 		samsung,vbus-gpio = <&gph0 1 GPIO_ACTIVE_HIGH>;
268 		samsung,vl-freq = <60>;
269 		samsung,vl-col = <1366>;
270 		samsung,vl-row = <768>;
271 		samsung,vl-width = <1366>;
272 		samsung,vl-height = <768>;
274 		samsung,vl-clkp;
275 		samsung,vl-dp;
276 		samsung,vl-bpix = <4>;
278 		samsung,vl-hspw = <32>;
279 		samsung,vl-hbpd = <40>;
280 		samsung,vl-hfpd = <40>;
281 		samsung,vl-vspw = <6>;
282 		samsung,vl-vbpd = <10>;
283 		samsung,vl-vfpd = <12>;
284 		samsung,vl-cmd-allow-len = <0xf>;
287 		samsung,interface-mode = <1>;
288 		samsung,dp-enabled = <1>;
289 		samsung,dual-lcd-enabled = <0>;
295 	samsung,color-space = <0>;
296 	samsung,dynamic-range = <0>;
297 	samsung,ycbcr-coeff = <0>;
298 	samsung,color-depth = <1>;
299 	samsung,link-rate = <0x06>;
300 	samsung,lane-count = <2>;
301 	samsung,hpd-gpio = <&gpx2 6 GPIO_ACTIVE_HIGH>;
306 				remote-endpoint = <&bridge_in>;
313 	spi-max-frequency = <3125000>;
314 	spi-deactivate-delay = <200>;
316 	num-cs = <1>;
317 	samsung,spi-src-clk = <0>;
318 	cs-gpios = <&gpb1 2 0>;
320 	cros_ec: cros-ec@0 {
321 		compatible = "google,cros-ec-spi";
322 		interrupt-parent = <&gpx1>;
325 		spi-half-duplex;
326 		spi-max-timeout-ms = <1100>;
327 		ec-interrupt = <&gpx1 5 GPIO_ACTIVE_LOW>;
328 		#address-cells = <1>;
329 		#size-cells = <1>;
332 		 * This describes the flash memory within the EC. Note
337 			erase-value = <0>;
340 		controller-data {
341 			samsung,spi-feedback-delay = <1>;
344 		i2c_tunnel: i2c-tunnel {
345 			compatible = "google,cros-ec-i2c-tunnel";
346 			#address-cells = <1>;
347 			#size-cells = <0>;
348 			google,remote-bus = <0>;
350 			battery: sbs-battery@b {
351 				compatible = "sbs,sbs-battery";
353 				sbs,poll-retry-count = <1>;
354 				sbs,i2c-retry-count = <2>;
357 			power-regulator@48 {
363 						ti,enable-ext-control;
366 						ti,enable-ext-control;
369 						ti,enable-ext-control;
372 						regulator-name = "vcd_led";
375 						regulator-name = "video_mid";
376 						regulator-always-on;
379 						regulator-name = "wwan_r";
380 						regulator-always-on;
383 						regulator-name = "sdcard";
384 						regulator-always-on;
387 						regulator-name = "camout";
388 						regulator-always-on;
391 						regulator-name = "lcd_vdd";
394 						regulator-name = "video_mid_1a";
395 						regulator-always-on;
404 					compatible = "ti,tps65090-charger";
411 #include "cros-ec-keyboard.dtsi"