Lines Matching +full:sda +full:- +full:gpios
7 * SPDX-License-Identifier: GPL-2.0
10 /dts-v1/;
11 #include <dt-bindings/gpio/gpio.h>
12 #include <dt-bindings/interrupt-controller/irq.h>
13 #include <dt-bindings/input/input.h>
53 stdout-path = "serial3:115200n8";
56 board-rev {
57 compatible = "google,board-revision";
58 google,board-rev-gpios = <&gpy4 0 0>, <&gpy4 1 0>,
63 clock-frequency = <100000>;
71 samsung,bus-width = <8>;
90 samsung,vbus-gpio = <&gpx1 1 GPIO_ACTIVE_HIGH>;
95 samsung,vbus-gpio = <&gpx2 7 GPIO_ACTIVE_HIGH>;
99 spi-max-frequency = <50000000>;
101 compatible = "spi-flash";
107 samsung,min-temp = <25>;
108 samsung,max-temp = <125>;
109 samsung,start-warning = <95>;
110 samsung,start-tripping = <105>;
111 samsung,hw-tripping = <110>;
112 samsung,efuse-min-value = <40>;
113 samsung,efuse-value = <55>;
114 samsung,efuse-max-value = <100>;
116 samsung,dc-value = <25>;
120 samsung,vl-freq = <60>;
121 samsung,vl-col = <1366>;
122 samsung,vl-row = <768>;
123 samsung,vl-width = <1366>;
124 samsung,vl-height = <768>;
126 samsung,vl-clkp;
127 samsung,vl-dp;
128 samsung,vl-hsp;
129 samsung,vl-vsp;
131 samsung,vl-bpix = <4>;
133 samsung,vl-hspw = <32>;
134 samsung,vl-hbpd = <80>;
135 samsung,vl-hfpd = <48>;
136 samsung,vl-vspw = <5>;
137 samsung,vl-vbpd = <14>;
138 samsung,vl-vfpd = <3>;
139 samsung,vl-cmd-allow-len = <0xf>;
142 samsung,interface-mode = <1>;
143 samsung,dp-enabled = <1>;
144 samsung,dual-lcd-enabled = <0>;
148 samsung,lt-status = <0>;
150 samsung,master-mode = <0>;
151 samsung,bist-mode = <0>;
152 samsung,bist-pattern = <0>;
153 samsung,h-sync-polarity = <0>;
154 samsung,v-sync-polarity = <0>;
156 samsung,color-space = <0>;
157 samsung,dynamic-range = <0>;
158 samsung,ycbcr-coeff = <0>;
159 samsung,color-depth = <1>;
163 compatible = "pwm-backlight";
165 brightness-levels = <0 100 500 1000 1500 2000 2500 2800>;
166 default-brightness-level = <1>;
167 enable-gpios = <&gpx3 0 GPIO_ACTIVE_HIGH>;
168 power-supply = <&fet1>;
173 power-supply = <&fet6>;
178 remote-endpoint = <&bridge_out>;
186 samsung,i2c-sda-delay = <100>;
187 samsung,i2c-max-bus-freq = <378000>;
189 s5m8767-pmic@66 {
190 compatible = "samsung,s5m8767-pmic";
192 interrupt-parent = <&gpx3>;
193 wakeup-source;
195 s5m8767,pmic-buck-dvs-gpios = <&gpd1 0 GPIO_ACTIVE_LOW>, /* DVS1 */
199 s5m8767,pmic-buck-ds-gpios = <&gpx2 3 GPIO_ACTIVE_LOW>, /* SET1 */
205 * not using GPIOs to control PMIC bucks, but they must be defined
208 s5m8767,pmic-buck2-dvs-voltage = <1350000>, <1300000>,
213 s5m8767,pmic-buck3-dvs-voltage = <1100000>, <1100000>,
218 s5m8767,pmic-buck4-dvs-voltage = <1200000>, <1200000>,
224 compatible = "samsung,s5m8767-clk";
225 #clock-cells = <1>;
226 clock-output-names = "en32khz_ap",
233 regulator-name = "P1.0V_LDO_OUT4";
234 regulator-min-microvolt = <1000000>;
235 regulator-max-microvolt = <1000000>;
236 regulator-always-on;
241 regulator-name = "P1.8V_LDO_OUT5";
242 regulator-min-microvolt = <1800000>;
243 regulator-max-microvolt = <1800000>;
244 regulator-always-on;
249 regulator-name = "vdd_mydp";
250 regulator-min-microvolt = <1200000>;
251 regulator-max-microvolt = <1200000>;
252 regulator-always-on;
257 regulator-name = "P1.1V_LDO_OUT7";
258 regulator-min-microvolt = <1100000>;
259 regulator-max-microvolt = <1100000>;
260 regulator-always-on;
265 regulator-name = "P1.0V_LDO_OUT8";
266 regulator-min-microvolt = <1000000>;
267 regulator-max-microvolt = <1000000>;
268 regulator-always-on;
273 regulator-name = "P1.8V_LDO_OUT10";
274 regulator-min-microvolt = <1800000>;
275 regulator-max-microvolt = <1800000>;
276 regulator-always-on;
281 regulator-name = "P1.8V_LDO_OUT11";
282 regulator-min-microvolt = <1800000>;
283 regulator-max-microvolt = <1800000>;
284 regulator-always-on;
289 regulator-name = "P3.0V_LDO_OUT12";
290 regulator-min-microvolt = <3000000>;
291 regulator-max-microvolt = <3000000>;
292 regulator-always-on;
297 regulator-name = "P1.8V_LDO_OUT13";
298 regulator-min-microvolt = <1800000>;
299 regulator-max-microvolt = <1800000>;
300 regulator-always-on;
305 regulator-name = "P1.8V_LDO_OUT14";
306 regulator-min-microvolt = <1800000>;
307 regulator-max-microvolt = <1800000>;
308 regulator-always-on;
313 regulator-name = "P1.0V_LDO_OUT15";
314 regulator-min-microvolt = <1000000>;
315 regulator-max-microvolt = <1000000>;
316 regulator-always-on;
321 regulator-name = "P1.8V_LDO_OUT16";
322 regulator-min-microvolt = <1800000>;
323 regulator-max-microvolt = <1800000>;
324 regulator-always-on;
329 regulator-name = "P1.2V_LDO_OUT17";
330 regulator-min-microvolt = <1200000>;
331 regulator-max-microvolt = <1200000>;
332 regulator-always-on;
337 regulator-name = "vdd_bridge";
338 regulator-min-microvolt = <1200000>;
339 regulator-max-microvolt = <1200000>;
340 regulator-always-on;
345 regulator-name = "vdd_mif";
346 regulator-min-microvolt = <950000>;
347 regulator-max-microvolt = <1300000>;
348 regulator-always-on;
349 regulator-boot-on;
354 regulator-name = "vdd_arm";
355 regulator-min-microvolt = <850000>;
356 regulator-max-microvolt = <1350000>;
357 regulator-always-on;
358 regulator-boot-on;
363 regulator-name = "vdd_int";
364 regulator-min-microvolt = <900000>;
365 regulator-max-microvolt = <1200000>;
366 regulator-always-on;
367 regulator-boot-on;
372 regulator-name = "vdd_g3d";
373 regulator-min-microvolt = <850000>;
374 regulator-max-microvolt = <1300000>;
375 regulator-boot-on;
380 regulator-name = "P1.8V_BUCK_OUT5";
381 regulator-min-microvolt = <1800000>;
382 regulator-max-microvolt = <1800000>;
383 regulator-always-on;
384 regulator-boot-on;
389 regulator-name = "P1.2V_BUCK_OUT6";
390 regulator-min-microvolt = <2050000>;
391 regulator-max-microvolt = <2050000>;
392 regulator-always-on;
393 regulator-boot-on;
398 regulator-name = "vdd_ummc";
399 regulator-min-microvolt = <950000>;
400 regulator-max-microvolt = <3000000>;
401 regulator-always-on;
402 regulator-boot-on;
411 samsung,color-space = <0>;
412 samsung,dynamic-range = <0>;
413 samsung,ycbcr-coeff = <0>;
414 samsung,color-depth = <1>;
415 samsung,link-rate = <0x0a>;
416 samsung,lane-count = <1>;
417 samsung,hpd-gpio = <&gpc3 0 GPIO_ACTIVE_HIGH>;
422 remote-endpoint = <&bridge_in>;
430 samsung,i2c-sda-delay = <100>;
431 samsung,i2c-max-bus-freq = <378000>;
436 samsung,i2c-sda-delay = <100>;
437 samsung,i2c-max-bus-freq = <66000>;
442 samsung,i2c-sda-delay = <100>;
443 samsung,i2c-max-bus-freq = <66000>;
448 samsung,i2c-sda-delay = <100>;
449 samsung,i2c-max-bus-freq = <66000>;
450 clock-frequency = <66000>;
452 cros_ec: embedded-controller {
453 compatible = "google,cros-ec-i2c";
456 interrupt-parent = <&gpx1>;
457 wakeup-source;
458 u-boot,i2c-offset-len = <0>;
459 ec-interrupt = <&gpx1 6 GPIO_ACTIVE_LOW>;
460 cros_ec_ldo_tunnel: cros-ec-ldo-tunnel {
461 compatible = "google,cros-ec-ldo-tunnel";
462 #address-cells = <1>;
463 #size-cells = <0>;
464 power-regulator {
470 ti,enable-ext-control;
473 ti,enable-ext-control;
476 ti,enable-ext-control;
479 regulator-name = "vcd_led";
480 ti,overcurrent-wait = <3>;
483 regulator-name = "video_mid";
484 regulator-always-on;
485 ti,overcurrent-wait = <3>;
488 regulator-name = "wwan_r";
489 regulator-always-on;
490 ti,overcurrent-wait = <3>;
493 regulator-name = "sdcard";
494 ti,overcurrent-wait = <3>;
497 regulator-name = "camout";
498 regulator-always-on;
499 ti,overcurrent-wait = <3>;
502 regulator-name = "lcd_vdd";
503 ti,overcurrent-wait = <3>;
506 regulator-name = "video_mid_1a";
507 regulator-always-on;
508 ti,overcurrent-wait = <3>;
522 samsung,i2c-sda-delay = <100>;
523 samsung,i2c-max-bus-freq = <66000>;
528 samsung,i2c-sda-delay = <100>;
529 samsung,i2c-max-bus-freq = <66000>;
531 ps8622-bridge@8 {
534 sleep-gpios = <&gpc3 6 GPIO_ACTIVE_LOW>;
535 reset-gpios = <&gpc3 1 GPIO_ACTIVE_LOW>;
536 hotplug-gpios = <&gpc3 0 GPIO_ACTIVE_HIGH>;
537 power-supply = <&ldo6_reg>;
562 0x04 0x7a 0xfd /* [7:5] DCO_FTRNG=+-40% */
568 0x04 0xc1 0x92 /* Gitune=-37% */
574 /* [7:6] Right-bar GPIO output strength is 8mA */
594 * 04h Adjust VTotal tolerance to fix the 30Hz no-
618 * Set LVDS output as 6bit-VESA mapping, single LVDS
623 /* Set SSC enabled and +/-1% central spreading */
626 0x04 0x54 0x14 /* LC -> RCO */
631 remote-endpoint = <&panel_in>;
637 remote-endpoint = <&dp_out>;
645 compatible = "maxim,max98088-codec";
649 #include "cros-ec-keyboard.dtsi"