Lines Matching +full:quad +full:- +full:core
1 # SPDX-License-Identifier: GPL-2.0-only
13 dynamic device discovery; some are even write-only or read-only.
17 chips, analog to digital (and d-to-a) converters, and more.
44 If your system has an master-capable SPI controller (which
56 by providing a high-level interface to send memory-like commands.
105 tristate "Atmel Quad SPI Controller"
109 This enables support for the Quad SPI controller in master mode.
111 supports spi-mem interface.
181 this code to manage the per-word or per-transfer accesses to the
205 tristate "Cadence Quad SPI controller"
208 Enable support for the Cadence Quad SPI Flash controller.
211 Flash over 1/2/4-bit wide bus. Enable this option if you have a
219 This enables dedicated general purpose SPI/Microwire1-compatible
220 master mode interface (SSI1) for CLPS711X-based CPUs.
230 tristate "Texas Instruments DaVinci/DA8x/OMAP-L/AM1x SoC SPI controller"
234 SPI master controller for DaVinci/DA8x/OMAP-L/AM1x SPI modules.
237 tristate "DesignWare SPI controller core support"
240 general driver for SPI controller core from DesignWare
248 tristate "PCI interface driver for DW SPI core"
252 tristate "Memory-mapped io interface driver for DW SPI core"
256 tristate "Baikal-T1 SPI driver for DW SPI core"
261 Baikal-T1 SoC is equipped with three DW APB SSI-based MMIO SPI
264 part of the Baikal-T1 System Boot Controller has got a very
266 chip-select and Tx/Rx FIFO with just 8 words depth available.
267 The later one is normally connected to an external SPI-nor flash
271 bool "Directly mapped Baikal-T1 Boot SPI flash support"
275 Baikal-T1 System Boot Controller. It is a 16MB MMIO region, which
280 time-critical tasks (like the SPI memory operations implemented
286 tristate "Diolan DLN-2 USB SPI adapter"
293 will be called spi-dln2.
313 The external bus unit (EBU) found on the FALC-ON SoC has SPI
336 This enables support for the Quad SPI controller in master mode.
340 supports the high-level SPI memory interface.
358 supports the high-level SPI memory interface.
361 tristate "GPIO-based bitbanging SPI Master"
365 This simple GPIO bitbanging SPI master uses the arch-neutral GPIO
391 tristate "J-Core SPI Master"
394 This enables support for the SPI master controller in the J-Core
407 tristate "ICP DAS LP-8841 SPI Controller for RTC"
411 DS-1302 real time clock.
414 LP-8x4x industrial computer.
417 tristate "Freescale MPC52xx SPI (non-PSC) controller support"
522 supports spi-mem interface.
573 This device supports single, dual and quad read support, while
596 tristate "Microchip PIC32 Quad SPI driver"
599 SPI driver for PIC32 Quad SPI controller.
649 If you say yes to this option, It will register rkspi-devN misc device
673 tristate "Renesas RPC-IF SPI driver"
676 SPI driver for Renesas R-Car Gen3 RPC-IF.
688 QSPI(Quad SPI) driver for Qualcomm QSPI controller.
694 Qualcomm Universal Peripheral (QUP) core is an AHB slave that
696 for serial peripheral interface (SPI) mini-core. SPI in master
709 yes to this option, support will be included for the built-in SPI
713 will be called spi-geni-qcom.
723 bool "S3C24XX driver with FIQ pseudo-DMA"
728 DMA by using the fast-interrupt request framework, This allows
729 the driver to get DMA-like performance when there are either
818 tristate "STMicroelectronics STM32 QUAD SPI controller"
822 This enables support for the Quad SPI controller in master mode.
824 supports spi-mem interface.
827 tristate "STMicroelectronics SPI SSC-based driver"
852 that use the de-facto standard SPI protocol.
854 It also supports the new dual-bit and quad-bit SPI protocol.
932 tristate "Analog Devices AD-FMCOMMS1-EBZ SPI-I2C-bridge driver"
935 Support for the SPI-I2C bridge found on the Analog Devices
936 AD-FMCOMMS1-EBZ board.
977 This enables support for the Zynq Quad SPI controller
1006 select one or more specific mux-controller drivers.
1053 If your system has a slave-capable SPI controller, you can enable