Lines Matching +full:sun4i +full:- +full:a10 +full:- +full:spi
1 # SPDX-License-Identifier: GPL-2.0-only
29 using the SPI interface. This driver provides common support for
44 tristate "Active-semi ACT8945A"
49 Support for the ACT8945A PMIC from Active-semi. This device
50 features three step-down DC/DC converters and four low-dropout
62 Select this to get support for Allwinner SoCs (A10, A13 and A31) ADC.
66 sun4i-gpadc-iio and the hwmon driver iio_hwmon.
69 called sun4i-gpadc.
88 tablets etc. It has 4 DC/DC step-down regulators, 3 DC/DC step-down
119 over at91-usart-serial driver and usart-spi-driver. Only one function
129 which embeds a SPI controller, a I2C controller and a USART. Only
135 tristate "Atmel HLCDC (High-end LCD Controller)"
172 tristate "X-Powers AC100"
176 If you say Y here you get support for the X-Powers AC100 audio codec
187 tristate "X-Powers AXP series PMICs with I2C"
192 If you say Y here you get support for the X-Powers AXP series power
204 tristate "X-Powers AXP series PMICs with RSB"
208 If you say Y here you get support for the X-Powers AXP series power
221 sub-devices. This driver will instantiate additional drivers such
225 called cros-ec-dev.
248 tristate "Cirrus Logic Madera codecs with SPI"
254 core functionality controlled via SPI.
306 usually found on PXA processors-based platforms. This includes
309 LEDs and battery-charger under the corresponding menus.
316 bool "Dialog Semiconductor DA9052/53 PMIC variants with SPI"
323 when controlled using SPI. This driver provides common support
381 tristate "Dialog Semiconductor DA9150 Charger Fuel-Gauge chip"
387 This adds support for the DA9150 integrated charger and fuel-gauge
397 This adds support for Diolan USB-I2C/SPI/GPIO Master Adapter
398 DLN-2. Additional drivers such as I2C_DLN2, GPIO_DLN2,
408 This adds support for the power-off functionality and access to
431 such as push-button monitor, multiple ADC's for voltage and
449 tristate "Freescale MC13783 and MC13892 SPI interface"
454 Select this if your MC13xxx is connected via an SPI bus.
481 Analog-to-Digital Converter (LRADC) found on the i.MX23 and i.MX28
485 mxs-lradc-adc for ADC readings
486 mxs-lradc-ts for touchscreen support
489 called mxs-lradc.
506 Add support for HiSilicon Hi6421 PMIC. Hi6421 includes multi-
511 We communicate with the Hi6421 via memory-mapped I/O.
530 handled by the leds-pasic3 and ds1wm drivers.
539 interface to one or more sub-chips.
551 The GPIO exports a total amount of 8 interrupt-capable GPIOs.
587 causes the designware-i2c driver to be builtin for the same reason.
614 causes the designware-i2c driver to be builtin for the same reason.
651 I2C, SPI and HS-UART starting from Intel Sunrisepoint (Intel Skylake
660 I2C, SPI and HS-UART starting from Intel Sunrisepoint (Intel Skylake
682 multi-function device that exposes IPC, General Control
683 Register and P-unit access. In addition this creates devices
703 IQS621, IQS622, IQS624 and IQS625 multi-function sensors. Additional
704 options must be selected to enable device-specific functions.
710 tristate "Janz CMOD-IO PCI MODULbus Carrier Board"
714 This is the core driver for the Janz CMOD-IO PCI MODULbus
728 * COMe-bBD#
729 * COMe-bBL6
730 * COMe-bHL6
731 * COMe-bSL6
732 * COMe-bIP#
733 * COMe-bKL6
734 * COMe-bPC2 (ETXexpress-PC)
735 * COMe-bSC# (ETXexpress-SC T#)
736 * COMe-cAL6
737 * COMe-cBL6
738 * COMe-cBT6
739 * COMe-cBW6
740 * COMe-cCT6
741 * COMe-cDC2 (microETXexpress-DC)
742 * COMe-cHL6
743 * COMe-cKL6
744 * COMe-cPC2 (microETXexpress-PC)
745 * COMe-cSL6
746 * COMe-mAL10
747 * COMe-mBT10
748 * COMe-mCT10
749 * COMe-mTT10 (nanoETXexpress-TT)
750 * ETX-OH
753 will be called kempld-core.
765 battery-charger under the corresponding menus.
788 battery-charger under the corresponding menus.
799 MAX77836 Micro-USB ICs with battery charger.
950 PMIC part includes 2-channel BUCKs and 2-channel LDOs
951 LDO part includes 4-channel LDOs
970 The device supports multiple sub-devices like LED, HWMON and WDT.
987 depends on SPI
1006 both gpios found on the board. The spi part does not yet
1012 tristate "Nokia Retu and Tahvo multi-function device"
1017 Retu and Tahvo are a multi-function devices found on Nokia
1028 so that function-specific drivers can bind to them.
1063 built-in PM8xxx PMIC chips.
1069 module. This will build a module called "pm8xxx-core".
1098 series as a module. The module will be called "qcom-spmi-pmic".
1101 tristate "RDC R-321x southbridge"
1105 Say yes here if you want to have support for the RDC R-321x SoC
1119 sub-devices like charger, fuel gauge, flash LED, current source,
1131 through i2c interface. The device supports multiple sub-devices
1173 tristate "RK630 SPI interface support"
1178 using SPI.
1188 through SPI interface. The device supports multiple sub-devices
1192 tristate "RK806 Power Management chip with SPI"
1197 If you say yes here you get support for the RK806 PM chips with SPI interface.
1209 through I2C interface. The device supports multiple sub-devices
1249 module will be called sec-core.
1261 radio. This MFD driver connects the radio-si476x V4L2 module
1265 module will be called si476x-core.
1273 to be shared by all sub-devices.
1276 sub-devices represented by child nodes in Device Tree will be
1289 * SMARC-sAL28
1330 This enables support for the Spreadtrum SC27xx PMICs with SPI
1339 bool "ST-Ericsson ABX500 Mixed Signal Circuit register functions"
1349 bool "ST-Ericsson AB3100 Mixed Signal Circuit core functions"
1358 this multi-functional IC. This is needed to use other features
1359 of the AB3100 such as battery-backed RTC, charging control,
1364 tristate "ST-Ericsson AB3100 OTP functions"
1368 Select this to enable the AB3100 Mixed Signal IC OTP (one-time
1373 bool "ST-Ericsson AB8500 Mixed Signal Power Management chip"
1380 chip. This connects to U8500 either on the SSP/SPI bus (deprecated
1394 bool "ST-Ericsson DB8500 Power Reset Control Management Unit"
1424 GPIO: stmpe-gpio
1425 Keypad: stmpe-keypad
1426 Touchscreen: stmpe-ts
1427 ADC: stmpe-adc
1440 bool "STMicroelectronics STMPE SPI Interface"
1443 This is used to enable SPI interface of STMPE
1551 high-power "white LED driver". This boost converter is
1642 designware-i2c driver to be built-in, for the same reason.
1730 tristate "TI TPS65912 Power Management chip with SPI"
1736 PM chips with SPI interface.
1748 step-down converters, 11 general purpose LDOs, USB OTG Module,
1761 so that function-specific drivers can bind to them.
1763 These multi-function chips are found on many OMAP2 and OMAP3
1777 This driver uses board-specific data to initialize the resources
1807 regulators, Dual slot memory card transceivers, real-time clock
1818 driver connects the radio-wl1273 V4L2 module and the wl1273
1832 backlight or ambient-light-sensor functionality of the device.
1843 for in-vehicle infontainment, called Russellville.
1887 tristate "TQ-Systems IO controller TQMX86"
1891 TQ-Systems IO controller and watchdog device, found on their
1927 tristate "Cirrus Logic/Wolfson Microelectronics Arizona platform with SPI"
1933 audio SoC core functionality controlled via SPI.
1994 bool "Wolfson Microelectronics WM831x/2x PMICs with SPI"
2002 when controlled using SPI. This driver provides common support
2028 The WM8994 is a highly integrated hi-fi CODEC designed for
2042 The WM9705, WM9712 and WM9713 is a highly integrated hi-fi CODEC
2056 in various ST Microelectronics and ST-Ericsson embedded
2081 Management IC. BD71837 is general purpose single-chip power
2082 management IC for battery-powered portable devices. It contains
2083 3 ultra-low current consumption buck converters, 3 LDOs and 2 LED
2084 drivers. Also included are 4 GPIOs, a real-time clock (RTC), a 32kHz
2085 crystal oscillator, high-accuracy VREF for use with an external ADC,
2098 Management IC. BD71828GW is a single-chip power management IC for
2099 battery-powered portable devices. The IC integrates 7 buck
2100 converters, 7 LDOs, and a 1500 mA single-cell linear charger.
2101 Also included is a Coulomb counter, a real-time clock (RTC), and
2105 tristate "Support for STM32 Low-Power Timer"
2111 Select this option to enable STM32 Low-Power Timer driver
2116 module will be called stm32-lptimer.
2146 tristate "Support for STMicroelectronics Multi-Function eXpander (STMFX)"
2152 Support for the STMicroelectronics Multi-Function eXpander.
2184 power-on options, power-off control and system FAN control on recent
2239 This option enables basic support for the SGI IOC3-based
2254 SPI interface.