Lines Matching +full:bcm6328 +full:- +full:power +full:- +full:controller
1 # SPDX-License-Identifier: GPL-2.0-only
50 See Documentation/ABI/testing/sysfs-class-led for details.
59 This option enables support for on-chip LED drivers found on Marvell
76 This option enables support for the AN30259A 3-channel
80 will be called leds-an30259a.
90 If you're looking for APU2/3, use the pcengines-apu2 driver.
94 module will be called leds-apu.
103 Controller.
113 controller. V4L2 flash API is provided as well if
120 This option enables support for the AW2013 3-channel
124 will be called leds-aw2013.
127 tristate "LED Support for Broadcom BCM6328"
132 This option enables support for LEDs connected to the BCM6328
133 LED HW controller accessed via MMIO registers.
142 LED HW controller accessed via MMIO registers.
164 will be called leds-cr0014114.
177 will be called leds-el15203000.
217 TI LM3533 Lighting Power chips.
220 ambient-light-sensor interface. The chip supports
221 hardware-accelerated blinking with maximum on and off periods of 9.8
230 The LM3642 is a 4MHz fixed-frequency synchronous boost
231 converter plus 1.5A constant current driver for a high-current
257 Zaurus models SL-5500 and SL-5600.
272 This option enables support for on-chip LED drivers found on
292 tristate "LED Support for the Freecom FSG-3"
296 This option enables support for the LEDs on the Freecom FSG-3.
350 LED controller. It is generally only useful
384 module will be called leds-lp3944.
397 module will be called leds-lp3952.
408 module will be called leds-lp50xx.
462 It is similar as LP5523, but output power selection is available.
492 The driver supports two kinds of interface: using ledtrig-timer
512 module will be called leds-clevo-mail.
564 This option enables support for on-chip LED drivers found
572 This option enables support for on-chip LED drivers found
573 on Dialog Semiconductor DA9052-BC and DA9053-AA/Bx PMICs.
613 drive or power LEDs on the front panel. Using this driver
623 LT3593 controller. This controller uses a special one-wire pulse
631 This option enables support for on-chip LED drivers found
635 be called leds-adp5520.
642 This option enables support for on-chip LED drivers found
651 This option enables support for the dual-GPIO LEDs found on the
657 n090401 (Seagate NAS 4-Bay)
677 ASIC3 LED GPIOs are inputs, not outputs, thus the leds-gpio driver
687 Driver support brightness control and hardware-assisted blinking.
718 This option enables support for on-chip LED drivers on
743 will be called leds-menf21bmc.
746 tristate "LED support for KTD2692 flash LED controller"
756 tristate "LED Support for ISSI IS31FL319x I2C LED controller family"
765 called leds-is31fl319x.
768 tristate "LED support for ISSI IS31FL32XX I2C LED controller family"
771 Say Y here to include support for ISSI IS31FL32XX and Si-En SN32xx
772 LED controllers. They are I2C devices with multiple constant-current
773 channels, each with independent 256-level PWM control.
776 tristate "LED support for DL3020RGB13H flash LED controller"
782 tristate "LED support for the SC27xx breathing light controller"
786 Say Y here to include support for the SC27xx breathing light controller
790 called leds-sc27xx-bltc.
811 will be called leds-powernv.
846 module, choose 'M' here: the module will be called leds-mlxreg.
865 will be called leds-nic78bx.
868 tristate "LED support for SPI LED controller with a single byte"
873 This option enables support for LED controller which use a single byte
874 for controlling the brightness. Currently the following controller is
875 supported: Ubiquiti airCube ISP microcontroller based LED controller.
921 will be called leds-ip30.
932 tristate "Power button LED support for Acer Iconia Tab A500"
935 This option enables support for the Power Button LED of