59 	[0] = {
60 		.hwport	     = 0,
61 		.flags	     = 0,
62 		.ucon	     = 0x2c5,
63 		.ulcon	     = 0x03,
64 		.ufcon	     = 0x51,
69 		.flags	     = 0,
71 		.ucon	     = 0x2c5,
72 		.ulcon	     = 0x43,
73 		.ufcon	     = 0x51,
79 		.flags	     = 0,
80 		.ucon	     = 0x2c5,
81 		.ulcon	     = 0x03,
82 		.ufcon	     = 0x51,
88 	.vbus_pin_inverted	= 0,
94 		.gpio		= S3C2410_GPF(0),
97 		.active_low	= 0,
103 		.active_low	= 0,
109 		.active_low	= 0,
115 		.active_low	= 0,
121 		.active_low	= 0,
127 		.active_low	= 0,
133 		.active_low	= 0,
139 		.active_low	= 0,
158 		.gpio		= S3C2410_GPF(0),
162 		.active_low	= 0,
169 		.active_low	= 0,
175 		.active_low	= 0,
181 		.active_low	= 0,
187 		.active_low	= 0,
193 		.active_low	= 0,
199 		.active_low	= 0,
205 		.active_low	= 0,
211 		.active_low	= 0,
217 		.active_low	= 0,
223 		.active_low	= 0,
229 		.active_low	= 0,
241 	.num_resources	= 0,
363 	.default_display = 0,
364 	.lpcsel		= 0x06,
378 		gpio_set_value(S3C2410_GPG(4), 0);  in n30_sdi_set_power()
397 		GPIO_LOOKUP_IDX("GPIOE",  5, "bus", 0, GPIO_ACTIVE_HIGH),
434 	.flags		= 0,
435 	.slave_addr	= 0x10,
449 	 * to make it an output there too since it always driven to 0  in n30_hwinit()
452 		__raw_writel(0x007fffff, S3C2410_GPACON);  in n30_hwinit()
454 		__raw_writel(0x007fefff, S3C2410_GPACON);  in n30_hwinit()
455 	__raw_writel(0x00000000, S3C2410_GPADAT);  in n30_hwinit()
459 	 * GPB2 output IrDA enable 0=transceiver enabled, 1=disabled  in n30_hwinit()
460 	 * GPB3 output USB D+ pull up 0=disabled, 1=enabled  in n30_hwinit()
462 	 *      N30/PiN GPS control 0=GPS enabled, 1=GPS disabled  in n30_hwinit()
470 	__raw_writel(0x00154556, S3C2410_GPBCON);  in n30_hwinit()
471 	__raw_writel(0x00000750, S3C2410_GPBDAT);  in n30_hwinit()
472 	__raw_writel(0x00000073, S3C2410_GPBUP);  in n30_hwinit()
479 	 * GPC5 output 0=NAND write enabled, 1=NAND write protect  in n30_hwinit()
481 	 * GPC7 input charger status 0=charger connected  in n30_hwinit()
489 	__raw_writel(0xaaa80618, S3C2410_GPCCON);  in n30_hwinit()
490 	__raw_writel(0x0000014c, S3C2410_GPCDAT);  in n30_hwinit()
491 	__raw_writel(0x0000fef2, S3C2410_GPCUP);  in n30_hwinit()
497 	 * GPD9 output 0=power led blinks red, 1=normal power led function  in n30_hwinit()
501 	__raw_writel(0xaa95aaa4, S3C2410_GPDCON);  in n30_hwinit()
502 	__raw_writel(0x00000601, S3C2410_GPDDAT);  in n30_hwinit()
503 	__raw_writel(0x0000fbfe, S3C2410_GPDUP);  in n30_hwinit()
510 	__raw_writel(0xa56aaaaa, S3C2410_GPECON);  in n30_hwinit()
511 	__raw_writel(0x0000efc5, S3C2410_GPEDAT);  in n30_hwinit()
512 	__raw_writel(0x0000f81f, S3C2410_GPEUP);  in n30_hwinit()
514 	/* GPF0  input 0=power button pressed  in n30_hwinit()
515 	 * GPF1  input SD/MMC switch 0=card present  in n30_hwinit()
517 	 *	 N35/PiN 0=reset button pressed  in n30_hwinit()
519 	 *       N35 input GPS antenna position, 0=antenna closed, 1=open  in n30_hwinit()
520 	 * GPF4  input 0=button 4 pressed  in n30_hwinit()
521 	 * GPF5  input 0=button 3 pressed  in n30_hwinit()
522 	 * GPF6  input 0=button 2 pressed  in n30_hwinit()
523 	 * GPF7  input 0=button 1 pressed  in n30_hwinit()
525 	__raw_writel(0x0000aaaa, S3C2410_GPFCON);  in n30_hwinit()
526 	__raw_writel(0x00000000, S3C2410_GPFDAT);  in n30_hwinit()
527 	__raw_writel(0x000000ff, S3C2410_GPFUP);  in n30_hwinit()
532 	 *       N35/PiN input 0=headphones plugged in, 1=not plugged in  in n30_hwinit()
535 	 * GPG4  N30 output 0=MMC enabled, 1=MMC disabled  in n30_hwinit()
536 	 * GPG5  N30 output 0=BlueTooth chip disabled, 1=enabled  in n30_hwinit()
538 	 * GPG6  N30 output 0=blue led on, 1=off  in n30_hwinit()
540 	 * GPG7  input 0=thumbwheel pressed  in n30_hwinit()
541 	 * GPG8  input 0=thumbwheel down  in n30_hwinit()
542 	 * GPG9  input 0=thumbwheel up  in n30_hwinit()
545 	 *       N35 output 0=GPS antenna powered, 1=not powered  in n30_hwinit()
553 		__raw_writel(0xff0a956a, S3C2410_GPGCON);  in n30_hwinit()
555 		__raw_writel(0xff4aa92a, S3C2410_GPGCON);  in n30_hwinit()
556 	__raw_writel(0x0000e800, S3C2410_GPGDAT);  in n30_hwinit()
557 	__raw_writel(0x0000f86f, S3C2410_GPGUP);  in n30_hwinit()
572 	__raw_writel(0x0028aaaa, S3C2410_GPHCON);  in n30_hwinit()
573 	__raw_writel(0x000005ef, S3C2410_GPHDAT);  in n30_hwinit()
574 	__raw_writel(0x0000063f, S3C2410_GPHUP);  in n30_hwinit()
608 			      S3C2410_MISCCR_USBSUSPND1, 0x0);  in n30_init()
611 	s3c_gpio_cfgall_range(S3C2410_GPE(0), 5, S3C_GPIO_SFN(2),  in n30_init()
619 				      S3C2410_MISCCR_USBSUSPND1, 0x0);  in n30_init()
658 	.atag_offset	= 0x100,
668 	.atag_offset	= 0x100,