boot/dts/rk3126c-evb-ddr3-v10-linux.dts

1 // SPDX-License-Identifier: (GPL-2.0+ OR MIT)
6 /dts-v1/;
7 #include <dt-bindings/gpio/gpio.h>
8 #include <dt-bindings/input/input.h>
9 #include <dt-bindings/pinctrl/rockchip.h>
10 #include <dt-bindings/pwm/pwm.h>
11 #include <dt-bindings/sensor-dev.h>
13 #include "rk312x-android.dtsi"
20 …on=uart8250,mmio32,0x20068000 console=ttyFIQ0 root=PARTUUID=614e0000-0000-4b53-8000-1d28000054a9 r…
23 	adc-keys {
24 		compatible = "adc-keys";
25 		io-channels = <&saradc 2>;
26 		io-channel-names = "buttons";
27 		poll-interval = <100>;
28 		keyup-threshold-microvolt = <3300000>;
30 		vol-up-key {
33 			press-threshold-microvolt = <0>;
36 		vol-down-key{
39 			press-threshold-microvolt = <400000>;
42 		menu-key{
45 			press-threshold-microvolt = <840000>;
48 		esc-key {
51 			press-threshold-microvolt = <1380000>;
56 		compatible = "pwm-backlight";
58 		brightness-levels = <0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
76 		default-brightness-level = <128>;
82 		io-channels = <&saradc 0>;
86 		compatible = "simple-audio-card";
87 		simple-audio-card,format = "i2s";
88 		simple-audio-card,mclk-fs = <256>;
89 		simple-audio-card,name = "rockchip,rk312x";
90 		simple-audio-card,cpu {
91 			sound-dai = <&i2s_2ch>;
93 		simple-audio-card,codec {
94 			sound-dai = <&codec>;
98 	vcc5v0_host: vcc5v0-host {
99 		compatible = "regulator-fixed";
100 		regulator-name = "vcc5v0_host";
101 		pinctrl-names = "default";
102 		pinctrl-0 = <&usb_hub_h>;
104 		enable-active-high;
107 	vccadc_ref: vccadc-ref {
108 		compatible = "regulator-fixed";
109 		regulator-name = "SARADC_AVDD33";
110 		regulator-always-on;
111 		regulator-boot-on;
112 		regulator-min-microvolt = <3300000>;
113 		regulator-max-microvolt = <3300000>;
116 	vcc_sys: vcc-sys {
117 		compatible = "regulator-fixed";
118 		regulator-name = "vcc_sys";
119 		regulator-min-microvolt = <4000000>;
120 		regulator-max-microvolt = <4000000>;
121 		regulator-always-on;
125 		compatible = "fixed-clock";
126 		clock-frequency = <32768>;
127 		clock-output-names = "xin32k";
128 		#clock-cells = <0>;
131 	wireless-wlan {
132 		compatible = "wlan-platdata";
148 				remote-endpoint =  <&gc0312_out>;
149 				vsync-active = <1>;
150 				hsync-active = <1>;
154 				remote-endpoint = <&gc2145_out>;
155 				vsync-active = <0>;
156 				hsync-active = <1>;
163 	#sound-dai-cells = <0>;
164 	spk-ctl-gpios = <&gpio2 9 GPIO_ACTIVE_HIGH>;
165 	spk-mute-delay = <200>;
166 	hp-mute-delay = <100>;
178 	cpu-supply = <&vdd_arm>;
186 	center-supply = <&vdd_log>;
193 		compatible = "sitronix,st7703", "simple-panel-dsi";
196 		power-supply = <&ldo6>;
197 		power-invert = <1>;
198 		prepare-delay-ms = <0>;
199 		reset-delay-ms = <0>;
200 		init-delay-ms = <80>;
201 		enable-delay-ms = <0>;
202 		disable-delay-ms = <10>;
203 		unprepare-delay-ms = <60>;
205 		width-mm = <68>;
206 		height-mm = <121>;
213 		panel-init-sequence = [
422 		panel-exit-sequence = [
427 		display-timings {
428 			native-mode = <&timing0>;
431 				clock-frequency = <66000000>;
434 				hfront-porch = <40>;
435 				hsync-len = <10>;
436 				hback-porch = <40>;
437 				vfront-porch = <22>;
438 				vsync-len = <4>;
439 				vback-porch = <11>;
440 				hsync-active = <0>;
441 				vsync-active = <0>;
442 				de-active = <0>;
443 				pixelclk-active = <0>;
448 			#address-cells = <1>;
449 			#size-cells = <0>;
454 					remote-endpoint = <&dsi_out_panel>;
461 		#address-cells = <1>;
462 		#size-cells = <0>;
467 				remote-endpoint = <&panel_in_dsi>;
474 	bus-width = <8>;
475 	cap-mmc-highspeed;
476 	supports-emmc;
477 	disable-wp;
478 	non-removable;
479 	num-slots = <1>;
485 	mali-supply = <&vdd_log>;
498 	clock-frequency = <400000>;
506 		clock-names = "xvclk";
508 		avdd-supply = <&vcc28_cif>;
509 		dovdd-supply = <&vcc18_cif>;
510 		dvdd-supply = <&vcc18_cif>;
512 		pwdn-gpios = <&gpio3 RK_PB3 GPIO_ACTIVE_HIGH>;
515 				remote-endpoint = <&cif_in_fcam>;
526 		clock-names = "xvclk";
527 		pwdn-gpios = <&gpio3 RK_PB3 GPIO_ACTIVE_HIGH>;
529 		avdd-supply = <&vcc28_cif>;
530 		dovdd-supply = <&vcc18_cif>;
531 		dvdd-supply = <&vcc18_cif>;
533 		rockchip,camera-module-index = <0>;
534 		rockchip,camera-module-facing = "back";
535 		rockchip,camera-module-name = "CameraKing";
536 		rockchip,camera-module-lens-name = "Largan";
540 				remote-endpoint = <&cif_in_bcam>;
548 		power-supply = <&ldo6>;
549 		power-invert = <1>;
550 		goodix,irq-gpio = <&gpio0 RK_PA0 IRQ_TYPE_LEVEL_LOW>;
569 		interrupt-parent = <&gpio0>;
571 		pinctrl-names = "default";
572 		pinctrl-0 = <&pmic_int_l>;
573 		rockchip,system-power-controller;
574 		wakeup-source;
575 		gpio-controller;
576 		#gpio-cells = <2>;
577 		#clock-cells = <1>;
578 		clock-output-names = "rk816-clkout1", "rk816-clkout2";
581 		vcc1-supply = <&vcc_sys>;
582 		vcc2-supply = <&vcc_sys>;
583 		vcc3-supply = <&vcc_sys>;
584 		vcc4-supply = <&vcc_sys>;
585 		vcc5-supply = <&vcc_io>;
586 		vcc6-supply = <&vcc_sys>;
601 			compatible = "rk816-battery";
626 				regulator-name= "vdd_arm";
627 				regulator-min-microvolt = <750000>;
628 				regulator-max-microvolt = <1500000>;
629 				regulator-ramp-delay = <6001>;
630 				regulator-initial-mode = <1>;
631 				regulator-always-on;
632 				regulator-boot-on;
633 				regulator-state-mem {
634 					regulator-off-in-suspend;
635 					regulator-suspend-microvolt = <900000>;
640 				regulator-name= "vdd_logic";
641 				regulator-min-microvolt = <750000>;
642 				regulator-max-microvolt = <1500000>;
643 				regulator-ramp-delay = <6001>;
644 				regulator-initial-mode = <1>;
645 				regulator-always-on;
646 				regulator-boot-on;
647 				regulator-state-mem {
648 					regulator-on-in-suspend;
649 					regulator-suspend-microvolt = <1000000>;
654 				regulator-name = "vcc_ddr";
655 				regulator-always-on;
656 				regulator-boot-on;
657 				regulator-initial-mode = <1>;
661 				regulator-name = "vcc_io";
662 				regulator-min-microvolt = <3300000>;
663 				regulator-max-microvolt = <3300000>;
664 				regulator-initial-mode = <1>;
665 				regulator-always-on;
666 				regulator-boot-on;
667 				regulator-state-mem {
668 					regulator-on-in-suspend;
669 					regulator-suspend-microvolt = <3000000>;
674 				regulator-name = "vcc28_cif";
675 				regulator-min-microvolt = <2800000>;
676 				regulator-max-microvolt = <2800000>;
677 				regulator-always-on;
678 				regulator-boot-on;
679 				regulator-state-mem {
680 					regulator-off-in-suspend;
685 				regulator-name = "vcc18_cif";
686 				regulator-min-microvolt = <1800000>;
687 				regulator-max-microvolt = <1800000>;
688 				regulator-always-on;
689 				regulator-boot-on;
690 				regulator-state-mem {
691 					regulator-off-in-suspend;
696 				regulator-name = "vdd_11";
697 				regulator-min-microvolt = <1100000>;
698 				regulator-max-microvolt = <1100000>;
699 				regulator-always-on;
700 				regulator-boot-on;
701 				regulator-state-mem {
702 					regulator-on-in-suspend;
703 					regulator-suspend-microvolt = <1100000>;
708 				regulator-name= "ldo4";
709 				regulator-min-microvolt = <3000000>;
710 				regulator-max-microvolt = <3000000>;
711 				regulator-always-on;
712 				regulator-boot-on;
713 				regulator-state-mem {
714 					regulator-off-in-suspend;
719 				regulator-name= "ldo5";
720 				regulator-min-microvolt = <3000000>;
721 				regulator-max-microvolt = <3000000>;
722 				regulator-boot-on;
723 				regulator-state-mem {
724 					regulator-off-in-suspend;
728 			ldo6: LDO_REG6 {  label
729 				regulator-name= "ldo6";
730 				regulator-min-microvolt = <3300000>;
731 				regulator-max-microvolt = <3300000>;
732 				regulator-state-mem {
733 					regulator-off-in-suspend;
734 					regulator-suspend-microvolt = <3300000>;
742 	#sound-dai-cells = <0>;
764 		pmic_int_l: pmic-int-l {
771 		usb_hub_h: usb-hub-h {
796 	vref-supply = <&vccadc_ref>;
800 	bus-width = <4>;
801 	max-frequency = <50000000>;
802 	cap-sd-highspeed;
803 	supports-sdio;
804 	ignore-pm-notify;
805 	keep-power-in-suspend;
806 	supports-rk912;
807 	/delete-property/ non-removable;
812 	cap-mmc-highspeed;
813 	supports-sd;
814 	card-detect-delay = <800>;
815 	ignore-pm-notify;
816 	keep-power-in-suspend;
817 	cd-gpios = <&gpio1 11 GPIO_ACTIVE_LOW>; /* CD GPIO */
828 	u2phy_otg: otg-port {
832 	u2phy_host: host-port {
833 		phy-supply = <&vcc5v0_host>;
839 	pinctrl-names = "default";
840 	pinctrl-0 = <&uart1_xfer>;