Lines Matching full:eth1
1216 must correspond with the name of the file, i.e., ifcfg-eth1 must have
1217 a device line of DEVICE=eth1. The setting of the MASTER= line will
1319 devices (presumed to be eth0 and eth1), and have it persist across
1327 ip link set eth1 master bond0
1549 and eth1), and have it persist across reboots, edit the appropriate
1559 echo +eth1 > /sys/class/net/bond0/bonding/slaves
1593 active-backup mode, with eth0 and eth1 as slaves::
1597 bond-slaves eth0 eth1
1600 bond-primary eth0 eth1
1616 bond-primary eth0 eth1
1618 auto eth1
1619 iface eth1 inet manual
1621 bond-primary eth0 eth1
1636 bonded interface in which eth0 connects to a private network, while eth1
1638 traffic over eth0 first, using eth1 only as a fall back, while all other traffic
1665 Slave Interface: eth1
1673 # echo "eth1:2" > /sys/class/net/bond0/bonding/queue_id
1683 force all traffic bound to 192.168.1.100 to use eth1 in the bond as its output
1695 selection policy to be overridden, selecting instead qid 2, which maps to eth1.
1777 Slave Interface: eth1
1797 (MASTER) while eth0 and eth1 are slaves (SLAVE). Notice all slaves of
1816 eth1 Link encap:Ethernet HWaddr 00:C0:F0:1F:37:B4
1994 device bond0 has two slaves, eth0 and eth1, and the routing table is
2000 10.0.0.0 0.0.0.0 255.255.0.0 U 40 0 0 eth1
2007 case, another host on network 10 would use eth0 or eth1 before bond0).
2037 alias eth1 tg3
2041 If neither eth0 and eth1 are slaves to bond0, then when the
2045 when the e1000 driver loads, it will receive eth0 and eth1 for its
2103 eth1 are slaves of bond0 and the driver for eth0 is loaded before the
2113 interfaces.ifTable.ifEntry.ifDescr.3 = eth1
2130 interfaces.ifTable.ifEntry.ifDescr.4 = eth1
2214 eth0 +-------+ eth1
2299 | |eth1 port2| | here somewhere
2326 | |eth1 port2| +------------------+ Host C |
2653 I/O Module #1; similarly, all eth1 ports are wired to I/O Module #2.
2677 modules 1 and 2. In this configuration, the eth0 and eth1 ports of a
2683 switch. By using PMs in I/O module #1 and #2, the eth0 and eth1