Lines Matching refs:ISA
82 Configuration program to setup ISA boards. Please note that
115 There are two types of buses, ISA and PCI, for Smartio/Industio
118 ISA board
124 Please make sure the JP1 is open after the ISA board is set properly.
130 with other ISA devices. Please refer to hardware installation
200 This driver will activate ISA boards according to the parameter set
201 in the driver. After all specified ISA board activated, PCI board
203 Therefore the board number is sorted by the CAP address of ISA boards.
204 For PCI boards, their sequence will be after ISA boards and C168H/PCI
280 if "mxser" is activated. If the MOXA board is ISA board, the
299 But if you use ISA board, please modify the "modprobe ..." command
322 If you'd like to drive Smartio/Industio ISA boards in the system,
329 | | | +- 4th ISA board
330 | | +------ 3rd ISA board
331 | +------------ 2nd ISA board
332 +-------------------1st ISA board
360 3.5.3 Add CAP address list for ISA boards.
365 In module mode, the CAP address for ISA board is given by
368 install any ISA boards, you may skip to next portion.
382 example, to driver 2 ISA boards with CAP address
583 Other PCI or ISA devices occupy the assigned IRQ. If you are not sure
595 No interrupt vector be set for Moxa ISA board(CAP=xxx).
598 Moxa ISA board needs an interrupt vector.Please refer to user's manual