bindings/thermal/rockchip-thermal.txt

4 - compatible : should be "rockchip,<name>-tsadc"
5    "rockchip,px30-tsadc":   found on PX30 SoCs
6    "rockchip,rv1108-tsadc": found on RV1108 SoCs
7    "rockchip,rv1126-tsadc": found on RV1126 SoCs
8    "rockchip,rk1808-tsadc": found on RK1808 SoCs
9    "rockchip,rk3228-tsadc": found on RK3228 SoCs
10    "rockchip,rk3288-tsadc": found on RK3288 SoCs
11    "rockchip,rk3308-tsadc": found on RK3308 SoCs
12    "rockchip,rk3328-tsadc": found on RK3328 SoCs
13    "rockchip,rk3368-tsadc": found on RK3368 SoCs
14    "rockchip,rk3399-tsadc": found on RK3399 SoCs
15    "rockchip,rk3568-tsadc": found on RK3568 SoCs
16    "rockchip,rk3588-tsadc": found on RK3588 SoCs
17 - reg : physical base address of the controller and length of memory mapped
19 - interrupts : The interrupt number to the cpu. The interrupt specifier format
21 - clocks : Must contain an entry for each entry in clock-names.
22 - clock-names : Shall be "tsadc" for the converter-clock, and "apb_pclk" for
24 - resets : Must contain an entry for each entry in reset-names.
26 - reset-names : Must include the name "tsadc-apb".
27 - pinctrl-names : The pin control state names;
28 - pinctrl-0 : The "gpio" pinctrl state, it will be set if tsadc via reset
30 - pinctrl-1 : The "otpout" pinctrl state, it will be set if tsadc via set
32 - #thermal-sensor-cells : Should be 1. See Documentation/devicetree/bindings/thermal/thermal-sensor…
35 - rockchip,hw-tshut-temp : The hardware-controlled shutdown temperature value.
36 - rockchip,hw-tshut-mode : The hardware-controlled shutdown mode 0:CRU 1:GPIO.
37 - rockchip,hw-tshut-polarity : The hardware-controlled active polarity 0:LOW
39 - rockchip,grf : The phandle of the syscon node for the general register file.
43 	compatible = "rockchip,rk3288-tsadc";
47 	clock-names = "tsadc", "apb_pclk";
49 	reset-names = "tsadc-apb";
50 	pinctrl-names = "gpio", "otpout";
51 	pinctrl-0 = <&otp_pin>;
52 	pinctrl-1 = <&otp_out>;
53 	#thermal-sensor-cells = <1>;
54 	rockchip,hw-tshut-temp = <95000>;
55 	rockchip,hw-tshut-mode = <0>;
56 	rockchip,hw-tshut-polarity = <0>;
59 Example: referring to thermal sensors:
60 thermal-zones {
62 		polling-delay-passive = <1000>; /* milliseconds */
63 		polling-delay = <5000>; /* milliseconds */
66 		thermal-sensors = <&tsadc	1>;
81 		cooling-maps {
84 				cooling-device =
85 				    <&cpu0 THERMAL_NO_LIMIT THERMAL_NO_LIMIT>;