bindings/phy/phy-rockchip-inno-usb3.txt

4  - compatible:	should be one of the listed compatibles:
5    * "rockchip,rk3328-u3phy"
6    * "rockchip,rk322xh-u3phy"
7  - reg : the base address of USB 3.0 PHY.
8  - rockchip,u3phygrf : phandle to the syscon managing the
10  - interrupts : specify an interrupt for each entry in interrupt-names.
11  - interrupt-names : a list which shall be the following entries:
13  - clocks : phandle + clock specifier for the phy clocks.
14  - clock-names :
15    * "u3phy-otg" for USB 3.0 PHY utmi
16    * "u3phy-pipe" for USB 3.0 PHY pipe
17  - resets : a list of phandle + reset specifier pairs
18  - reset-names :
19    * "u3phy-u2-por" for the USB 2.0 logic of USB 3.0 PHY
20    * "u3phy-u3-por" for the USB 3.0 logic of USB 3.0 PHY
21    * "u3phy-pipe-mac" for the USB 3.0 PHY pipe MAC
22    * "u3phy-utmi-mac" for the USB 3.0 PHY utmi MAC
23    * "u3phy-utmi-apb" for the USB 3.0 PHY utmi apb
24    * "u3phy-pipe-apb" for the USB 3.0 PHY pipe apb
27  - vbus-supply: regulator phandle for vbus power source.
29 Required nodes : a sub-node is required for USB 3.0 or USB 2.0 the phy provides.
30 		 The sub-node name is used to identify phy type, and shall be
35 Required properties (port (child) node):
36  - reg : address and length of the register set for the port.
37  - #phy-cells : must be 0. See ./phy-bindings.txt for details.
40  - rockchip,odt-val-tuning : specify 45ohm ODT tuning value.
43  - rockchip,refclk-25m-quirk : phy reference clock changed to 25m quirk.
48 	compatible = "rockchip,usb3phy-grf", "syscon";
54 u3phy: usb3-phy@ff470000 {
55 	compatible = "rockchip,rk3328-u3phy";
59 	interrupt-names = "linestate";
61 	clock-names = "u3phy-otg", "u3phy-pipe";
68 	reset-names = "u3phy-u2-por", "u3phy-u3-por",
69 		      "u3phy-pipe-mac", "u3phy-utmi-mac",
70 		      "u3phy-utmi-apb", "u3phy-pipe-apb";
71 	#address-cells = <2>;
72 	#size-cells = <2>;
77 		#phy-cells = <0>;
82 		#phy-cells = <0>;