bindings/net/micrel.txt

7  - micrel,led-mode : LED mode value to set for PHYs with configurable LEDs.
9 	Configure the LED mode with single value. The list of PHYs and the
20 	See the respective PHY datasheet for the mode values.
22  - micrel,rmii-reference-clock-select-25-mhz: RMII Reference Clock Select
23 						bit selects 25 MHz mode
26 	than 50 MHz clock mode.
29 	non-standard, inverted function of this configuration bit.
30 	Specifically, a clock reference ("rmii-ref" below) is always needed to
31 	actually select a mode.
33  - clocks, clock-names: contains clocks according to the common clock bindings.
36 	- KSZ8021, KSZ8031, KSZ8081, KSZ8091: "rmii-ref": The RMII reference
39  - micrel,fiber-mode: If present the PHY is configured to operate in fiber mode
41 	Some PHYs, such as the KSZ8041FTL variant, support fiber mode, enabled
43 	registers whether the PHY is in fiber mode, so this boolean device tree
46 	In fiber mode, auto-negotiation is disabled and the PHY can only work in
47 	100base-fx (full and half duplex) modes.