Lines Matching refs:bttv

4 The bttv driver
7 Release notes for bttv
10 You'll need at least these config options for bttv::
29 Make bttv work with your card
32 If you have bttv compiled and installed, just booting the Kernel
38 If it doesn't bttv likely could not autodetect your card and needs some
39 insmod options.  The most important insmod option for bttv is "card=n"
42 cards is in :doc:`bttv-cardlist`.
44 If bttv takes very long to load (happens sometimes with the cheap
60 If your card isn't listed in :doc:`bttv-cardlist` or if you have
67 bttv uses the PCI Subsystem ID to autodetect the card type.  lspci lists
80 at :doc:`bttv-cardlist` (in case you are intrested or want to mail
126 bttv
164 			    push used by bttv.  bttv will disable overlay
242 If the box freezes hard with bttv
245 It might be a bttv driver bug.  It also might be bad hardware.  It also
248 Just mailing me "bttv freezes" isn't going to help much.  This README
252 bttv bugs
274 I've seen reports that bttv 0.7.x crashes whereas 0.8.x works rock solid
275 for some people.  Thus probably a small buglet left somewhere in bttv
285 Sometimes problems show up with bttv just because of the high load on
291 only makes it less likely to happen.  Both bttv and btaudio have a
295 doing DMA at the same time.  bttv + ide seems to cause this sometimes,
309 try to shuffle around the PCI cards to give bttv another IRQ or make
312 effects with bttv sharing the IRQ with the ACPI bridge (and
328 messages, bttv tells you).
789     modprobe bttv  tuner=1 pll=28 radio=1 card=17
792 FM radio and selects bttv card ID 17 (Leadtek WinView 601).
1657 Chips used at bttv devices