Lines Matching refs:file

4 Subject: [PATCH] arm/arm64: zynq/zynqmp: pass the PS init file as a kconfig
8 ZynqMP (PS init for short). The current logic to locate this file for
11  1. if a board-specific file exists in
16 In the latter case the file does not exist in the U-Boot sources and
20 board-specific file is _not_ found (and used) requires some trickery
29  * any buildsystem must add a command to copy the PS init file binary
33 file in kconfig variable XILINX_PS_INIT_FILE. It can be an absolute
35 user-specified file will always be used without being copied
43 U-Boot the PS init file.
47  - PS init file: from XILINX_PS_INIT_FILE (absolute, relative path,
79 new file mode 100644
91 +	string "Zynq/ZynqMP PS init file(s) location"
96 +	  configuring pinmuxes. The PS init file (called
105 +	  There are three ways to give a PS init file to U-Boot:
109 +	     ps7_init_gpl.c file is located. U-Boot will build this
110 +	     file.
118 +	  3. If the above file does not exist, U-Boot will use
120 +	     board/xilinx/zynqmp/psu_init_gpl.c for ZynqMP. This file