Lines Matching +full:buildroot +full:- +full:pipeline

5 This file documents the Buildroot support for the Freescale i.MX6 Sabre SD
8 Thanks to the SPL support in U-Boot it is possible to run a single
11 This configuration uses U-Boot mainline and kernel mainline.
16 First, configure Buildroot for the i.MX6 Sabre SD board:
18   make imx6-sabresd_defconfig
25   - imx6q-sabresd.dtb
26   - imx6dl-sabresd.dtb
27   - imx6qp-sabresd.dtb
28   - rootfs.ext4
29   - rootfs.tar
30   - sdcard.img
31   - u-boot.imx
32   - zImage
42 Buildroot prepares a bootable "sdcard.img" image in the output/images/
46   dd if=output/images/sdcard.img of=/dev/<your-sd-device>
57 - insert the SD card in the SD3 slot of the board (close to the HDMI connector);
58 - put a micro USB cable into the Debug USB Port and connect using a terminal
60 - power on the board.
65 The imx6-sabresd_qt5_defconfig allows to quickly test the graphics
71 make imx6-sabresd_qt5_defconfig
88 # glmark2-es2-drm
102 In the mx6sabresd prompt run the following Gstreamer pipeline:
104 # gst-launch-1.0 filesrc location=/root/trailer_1080p_h264_mp3.avi ! avidemux ! \
105 h264parse ! v4l2video1dec capture-io-mode=dmabuf ! kmssink connector-id=37    \
106 name=imx-drm sync=0