Lines Matching +full:bit +full:- +full:banging

2  * acme-acqua.dts - Device Tree file for Acqua A5 Board
11 /dts-v1/;
19 stdout-path = "serial0:115200n8";
29 clock-frequency = <32768>;
33 clock-frequency = <12000000>;
41 hlcdc-display-controller {
42 pinctrl-names = "default";
43 pinctrl-0 = <&pinctrl_lcd_base &pinctrl_lcd_rgb888_alt>;
46 remote-endpoint = <&panel_input>;
55 pinctrl-0 = <&pinctrl_mmc0_clk_cmd_dat0 &pinctrl_mmc0_dat1_3 &pinctrl_mmc0_cd>;
59 bus-width = <4>;
66 pinctrl-0 = <&pinctrl_mmc1_clk_cmd_dat0 &pinctrl_mmc1_dat1_3 &pinctrl_mmc1_cd>;
70 bus-width = <4>;
71 cd-gpios = <&pioE 1 GPIO_ACTIVE_LOW>;
76 cs-gpios = <&pioD 13 0>, <0>, <0>, <&pioD 16 0>;
86 compatible = "atmel,tcb-timer";
91 compatible = "atmel,tcb-timer";
97 pinctrl-0 = <&pinctrl_i2c0_pu>;
106 compatible = "atmel,sama5d3-macb", "cdns,at91sam9260-macb", "cdns,macb";
109 phy-mode = "rmii";
110 #address-cells = <1>;
111 #size-cells = <0>;
113 nvmem-cells = <&eth0_addr>;
114 nvmem-cell-names = "mac-address";
116 phy0: ethernet-phy@1 {
117 interrupt-parent = <&pioE>;
122 /*ethernet-phy@1 {
127 /* Bit banging internal I2C to manage the AT24MAC402 chip */
130 compatible = "i2c-gpio";
134 i2c-gpio,delay-us = <4>; /* ~178 kHz */
135 #address-cells = <1>;
136 #size-cells = <0>;
143 read-only;
145 #address-cells = <1>;
146 #size-cells = <1>;
148 eth0_addr: eth-mac-addr@9A {
155 pinctrl-names = "default";
156 pinctrl-0 = <&pinctrl_pwm0_pwmh0_0 &pinctrl_pwm0_pwmh1_0>;
165 pinctrl-0 = <&pinctrl_usart1 &pinctrl_usart1_rts_cts>;
175 cs-gpios = <&pioC 25 0>;
180 atmel,adc-vref = <3300>;
181 atmel,adc-channels-used = <0xfe>;
182 pinctrl-0 = <
197 pinctrl-0 = <&pinctrl_i2c2_pu>;
259 /* compatible = "acme,43inch", "simple-panel"; */
260 compatible = "acme,50inch", "simple-panel";
261 /* compatible = "acme,70inch", "simple-panel"; */
267 remote-endpoint = <&hlcdc_panel_output>;
274 compatible = "gpio-leds";
279 default-state = "off";
285 default-state = "off";
291 linux,default-trigger = "heartbeat";
297 linux,default-trigger = "mmc0";
298 default-state = "off";