board: atmel: use get_nand_dev_by_index()

As part of preparation for nand DM conversion the new API has been
introduced to remove direct access to nand_info array. So, use it here
instead of accessi

board: atmel: use get_nand_dev_by_index()

As part of preparation for nand DM conversion the new API has been
introduced to remove direct access to nand_info array. So, use it here
instead of accessing to nand_info array directly.

Signed-off-by: Grygorii Strashko <grygorii.strashko@ti.com>

show more ...

Merge git://git.denx.de/u-boot-dm

board: at91sam9n12ek: Enable early debug UART

Enable the early debug UART to debug problems when an ICE or other
debug mechanism is not available.

Signed-off-by: Wenyou Yang <wenyou.yang@atmel.com>

board: at91sam9n12ek: Enable early debug UART

Enable the early debug UART to debug problems when an ICE or other
debug mechanism is not available.

Signed-off-by: Wenyou Yang <wenyou.yang@atmel.com>
Reviewed-by: Simon Glass <sjg@chromium.org>

show more ...

board: at91sam9n12ek: Clean up code

Since the introduction of the pinctrl and clk driver and the device
tree files, remove unneeded related code from the board file.

Signed-off-by: Wenyou Yang <wen

board: at91sam9n12ek: Clean up code

Since the introduction of the pinctrl and clk driver and the device
tree files, remove unneeded related code from the board file.

Signed-off-by: Wenyou Yang <wenyou.yang@atmel.com>
Reviewed-by: Simon Glass <sjg@chromium.org>

show more ...

configs: at91sam9n12ek: Update for DT and DM support

Update the configuration files to support the device tree and driver
model. The device clock and pins configuration are handled by the
clock and

configs: at91sam9n12ek: Update for DT and DM support

Update the configuration files to support the device tree and driver
model. The device clock and pins configuration are handled by the
clock and the pinctrl drivers respectively.

Because the limitation of internal SRAM size, the SPL with driver
model can't be supported, disable the SPL option.

Signed-off-by: Wenyou Yang <wenyou.yang@atmel.com>
Reviewed-by: Simon Glass <sjg@chromium.org>

show more ...

Merge git://git.denx.de/u-boot-dm

Here with some DM changes as well as the long-standing AT91 DM/DT
conversion patches which I have picked up via dm.

gpio: at91_gpio: remove CPU_HAS_PIO3 macro

The intention of the removal is the preparation to introduce the
new AT91 PIO pinctrl driver.

Use the union to make the PIO3 and PIO2's registers be toget

gpio: at91_gpio: remove CPU_HAS_PIO3 macro

The intention of the removal is the preparation to introduce the
new AT91 PIO pinctrl driver.

Use the union to make the PIO3 and PIO2's registers be together
and make their offset aligned.

Signed-off-by: Wenyou Yang <wenyou.yang@atmel.com>
Reviewed-by: Simon Glass <sjg@chromium.org>

show more ...

Merge branch 'master' of git://git.denx.de/u-boot

Signed-off-by: Stefano Babic <sbabic@denx.de>

Merge git://git.denx.de/u-boot-nand-flash

nand: Embed mtd_info in struct nand_chip

nand_info[] is now an array of pointers, with the actual mtd_info
instance embedded in struct nand_chip.

This is in preparation for syncing the NAND code wi

nand: Embed mtd_info in struct nand_chip

nand_info[] is now an array of pointers, with the actual mtd_info
instance embedded in struct nand_chip.

This is in preparation for syncing the NAND code with Linux 4.6,
which makes the same change to struct nand_chip. It's in a separate
commit due to the large amount of changes required to accommodate the
change to nand_info[].

Signed-off-by: Scott Wood <oss@buserror.net>

show more ...

Merge branch 'master' of git://git.denx.de/u-boot-atmel

board: atmel: clean up peripheral clock code

Due to introducing the new peripheral clock handle functions,
use these functions to reduce duplicated code.

Signed-off-by: Wenyou Yang <wenyou.yang@atm

board: atmel: clean up peripheral clock code

Due to introducing the new peripheral clock handle functions,
use these functions to reduce duplicated code.

Signed-off-by: Wenyou Yang <wenyou.yang@atmel.com>
Tested-by: Heiko Schocher <hs@denx.de>
[Rebased on current master, fixup for at91rm9200ek]
Signed-off-by: Andreas Bießmann <andreas.devel@googlemail.com>

show more ...

Merge branch 'master' of git://git.denx.de/u-boot-atmel

arm: at91/spl: mpddrc: add struct atmel_mpddrc_config

Add struct atmel_mpddrc_config to accommodate the mpddrc register
configurations, not using the mpddrc register map structure,
struct atmel_mpdd

arm: at91/spl: mpddrc: add struct atmel_mpddrc_config

Add struct atmel_mpddrc_config to accommodate the mpddrc register
configurations, not using the mpddrc register map structure,
struct atmel_mpddrc, in order to increase readability and reduce
run-time memory use.

Signed-off-by: Wenyou Yang <wenyou.yang@atmel.com>
Reviewed-by: Andreas Bießmann <andreas.devel@googlemail.com>

show more ...

arm: at91: pmc: replace the constant with a define in at91_pmc.h

To enable the clocks on the at91 boards a constant (0x4) is used.
This is replaced with a define in at91_pmc.h (1 << 2).

Signed-off

arm: at91: pmc: replace the constant with a define in at91_pmc.h

To enable the clocks on the at91 boards a constant (0x4) is used.
This is replaced with a define in at91_pmc.h (1 << 2).

Signed-off-by: Erik van Luijk <evanluijk@interact.nl>
Reviewed-by: Andreas Bießmann <andreas.devel@googlemail.com>

show more ...

arm: at91: mpddr: allow multiple DDR controllers

The mpddr.c depends on ATMEL_BASE_MPDDRC for the base address to configure the controller.
This cannot be used when there is more than one controller

arm: at91: mpddr: allow multiple DDR controllers

The mpddr.c depends on ATMEL_BASE_MPDDRC for the base address to configure the controller.
This cannot be used when there is more than one controller (i.e. AT91SAM9G45, AT91SAM9M10).

Signed-off-by: Erik van Luijk <evanluijk@interact.nl>
[remove 'new blank line at EOF']
Signed-off-by: Andreas Bießmann <andreas.devel@googlemail.com>

show more ...

Merge branch 'u-boot/master'

Merge branch 'master' of git://git.denx.de/u-boot-atmel

ARM: atmel: at91sam9n12ek: enable spl support

Enable SPL support for at91sam9n12ek boards, now it supports
boot up from NAND flash, serial flash.

Signed-off-by: Bo Shen <voice.shen@atmel.com>

Merge branch 'iu-boot/master' into 'u-boot-arm/master'

Conflicts:
arch/arm/cpu/arm926ejs/mxs/Makefile
board/compulab/cm_t35/Makefile
board/corscience/tricorder/Makefile
board/ppcag/bg0900/Makefi

Merge branch 'iu-boot/master' into 'u-boot-arm/master'

Conflicts:
arch/arm/cpu/arm926ejs/mxs/Makefile
board/compulab/cm_t35/Makefile
board/corscience/tricorder/Makefile
board/ppcag/bg0900/Makefile
drivers/bootcount/Makefile
include/configs/omap4_common.h
include/configs/pdnb3.h

Makefile conflicts are due to additions/removals of
object files on the ARM branch vs KBuild introduction
on the main branch. Resolution consists in adjusting
the list of object files in the main branch version.
This also applies to two files which are not listed
as conflicting but had to be modified:

board/compulab/common/Makefile
board/udoo/Makefile

include/configs/omap4_common.h conflicts are due to
the OMAP4 conversion to ti_armv7_common.h on the ARM
side, and CONFIG_SYS_HZ removal on the main side.
Resolution is to convert as this icludes removal of
CONFIG_SYS_HZ.

include/configs/pdnb3.h is due to a removal on ARM side.
Trivial resolution is to remove the file.

Note: 'git show' will also list two files just because
they are new:

include/configs/am335x_igep0033.h
include/configs/omap3_igep00x0.h

show more ...

Merge branch 'u-boot-atmel/master' into 'u-boot-arm/master'

arm: atmel: at91sam9n12ek: add usb host support

Add usb host support for at91sam9n12ek board.

Signed-off-by: Bo Shen <voice.shen@atmel.com>
Signed-off-by: Andreas Bießmann <andreas.devel@googlemail

arm: atmel: at91sam9n12ek: add usb host support

Add usb host support for at91sam9n12ek board.

Signed-off-by: Bo Shen <voice.shen@atmel.com>
Signed-off-by: Andreas Bießmann <andreas.devel@googlemail.com>

show more ...

Merge git://git.denx.de/u-boot-arm

Conflicts:
board/freescale/mx6qsabrelite/Makefile
board/freescale/mx6qsabrelite/mx6qsabrelite.c
include/configs/mx6qsabrelite.h

Signed-off-by: Stefano Babic <s

Merge git://git.denx.de/u-boot-arm

Conflicts:
board/freescale/mx6qsabrelite/Makefile
board/freescale/mx6qsabrelite/mx6qsabrelite.c
include/configs/mx6qsabrelite.h

Signed-off-by: Stefano Babic <sbabic@denx.de>

show more ...

Merge branch 'u-boot/master' into u-boot-arm/master

Add GPL-2.0+ SPDX-License-Identifier to source files

Signed-off-by: Wolfgang Denk <wd@denx.de>
[trini: Fixup common/cmd_io.c]
Signed-off-by: Tom Rini <trini@ti.com>