Merge changes from topic "imx8ulp_support" into integration

* changes:
docs(maintainers): add the maintainers for imx8ulp
docs(imx8ulp): add imx8ulp platform
fix(imx8ulp): increase the mmap re

Merge changes from topic "imx8ulp_support" into integration

* changes:
docs(maintainers): add the maintainers for imx8ulp
docs(imx8ulp): add imx8ulp platform
fix(imx8ulp): increase the mmap region num
feat(imx8ulp): adjust the dram mapped region
feat(imx8ulp): ddrc switch auto low power and software interface
feat(imx8ulp): add some delay before cmc1 access
feat(imx8ulp): add a flag check for the ddr status
fix(imx8ulp): add sw workaround for csi/hotplug test hang
feat(imx8ulp): adjust the voltage when sys dvfs enabled
feat(imx8ulp): enable the DDR frequency scaling support
fix(imx8ulp): fix suspend/resume issue when DBD owner is s400 only
feat(imx8ulp): update XRDC for ELE to access DDR with CA35 DID
feat(imx8ulp): add memory region policy
feat(imx8ulp): protect TEE region for secure access only
feat(imx8ulp): add trusty support
feat(imx8ulp): add OPTEE support
feat(imx8ulp): update the upower config for power optimization
feat(imx8ulp): allow RTD to reset APD through MU
feat(imx8ulp): not power off LPAV PD when LPAV owner is RTD
feat(imx8ulp): add system power off support
feat(imx8ulp): add APD power down mode(PD) support in system suspend
feat(imx8ulp): add the basic support for idle & system suspned
feat(imx8ulp): enable 512KB cache after resume on imx8ulp
feat(imx8ulp): add the initial XRDC support
feat(imx8ulp): allocated caam did for the non secure world
feat(imx8ulp): add i.MX8ULP basic support
build(changelog): add new scopes for nxp imx8ulp platform
feat(scmi): add scmi sensor support

show more ...

fix(imx8ulp): fix suspend/resume issue when DBD owner is s400 only

After resume from APD power down, XRDC is initialized by S400 but
the PAC2 and MSC0-2 are not configured, so only DBD owner can acc

fix(imx8ulp): fix suspend/resume issue when DBD owner is s400 only

After resume from APD power down, XRDC is initialized by S400 but
the PAC2 and MSC0-2 are not configured, so only DBD owner can access
the resources.

We have to move GPIO restore after TFA XRDC reinit and configure
PDAC for PCC5 before enabling eDMA2 MP clock

Signed-off-by: Ye Li <ye.li@nxp.com>
Signed-off-by: Jacky Bai <ping.bai@nxp.com>
Change-Id: I82748de080151b0bdf1cace092b7892a1e402a27

show more ...

feat(imx8ulp): add the initial XRDC support

Add the initial xRDC support on i.MX8ULP.

Signed-off-by: Ye Li <ye.li@nxp.com>
Signed-off-by: Peng Fan <peng.fan@nxp.com>
Signed-off-by: Jacky Bai <ping.

feat(imx8ulp): add the initial XRDC support

Add the initial xRDC support on i.MX8ULP.

Signed-off-by: Ye Li <ye.li@nxp.com>
Signed-off-by: Peng Fan <peng.fan@nxp.com>
Signed-off-by: Jacky Bai <ping.bai@nxp.com>
Change-Id: I93ea8e2cebb049e6f20e71cfe50c7583a3228f38

show more ...